Dacor ER30DSRSCHNGH Uso Y Cuidado

9

Setting Up Your Range

Control Panel Settings

Setting the Time

IMPORTANT:
•  The clock cannot be set during delay timed cooking or 

if one or both timers are in use.

•  After a power failure, the time on the display may 

flash, indicating that the time may not be correct.

1.  Press the CLOCK key. “TIME” will flash on the dis-

play.

2.  Enter the current time and press START. For exam-

ple: For 12:08 Press 1-2-0-8 on the keypad, then 

START.

IMPORTANT: After pressing the clock key, you must 

enter the time and press START soon afterward. If you 

wait longer than six seconds between pressing keys, the 

display will go back to the original setting.

24/12 Hour Clock (Military Time)

The range is set to 12-hour (non-military) time at the fac-

tory. 24- hour time is also known as military time.  

1:36 

p

.

m

. = 13:36 military time.

1.  Press and hold the clock key for six seconds. The 

display will indicate the mode the clock is currently set 

to, 12 HR or 24 HR.

2.  Press the SELF-CLEAN key within six seconds to 

change the clock mode. To leave the setting as is, do 

not touch any keys.

3.  Wait six seconds. The control panel will go back to the 

regular clock display, set to the new time standard. 

If you have set the clock to 24 hour time, the keypad 

will allow you to enter military time when setting the 

clock.

Setting the Temperature Scale

The control panel allows you to select the temperature 

scale (Fahrenheit or Celsius) it uses to display the cooking 

temperature. The oven is preset at the factory to Fahren-

heit.

1.  Press and hold the BROIL key for six seconds.
2.  The display will indicate the temperature scale the 

control panel is currently set to, “F” or “C”.

3.  Press the SELF-CLEAN key within six seconds to 

change the temperature scale. To leave the setting as 

is, do not touch any keys.

4.  Wait six seconds. The control panel will go back to 

the regular clock display, set to the new temperature 

scale.

Control Panel Position

The control panel can be swiveled to a 50° angle for 

easier viewing and use.

1.  Push in on the bottom of the control panel where it 

says “PRESS HERE”. The control panel will pivot up.

2.  Pull up on the bottom of the control panel housing 

(under “PRESS HERE”) until it locks in place.

1.  Pull up on the bottom of the control panel housing 

(under “PRESS HERE”) to unlock it.

2.  Push in where it says “PRESS HERE” until it locks into 

the vertical position.

When changing the control panel position, push in only on the 

spot marked “

PRESS HERE.” If you push in on the right or left 

side you may damage the pivot mechanism.

Clock key

Press here

Press here