Zephyr ZNAE42CS Manual

www.zephyronline.com

Display (speed level, delay off, filter clean/change,clean air)

  Power Button Function
-       Button will turn power on and off for entire hood (fan and lights).
- Hood will remember the last speed and light level it was turned off at.

(Example: Press      Button to turn off hood when on fan speed 4 and high lights. Press       Button again and the hood  
will turn back on at speed 4 and high lights level.)

  Delay Off Button Function
- Press and hold      Button for two seconds and the fan will turn on speed 1. The       Graphic will illuminate. After five minutes  
  the fan and lights will automatically turn off.
- Pressing      Button while Delay Off Function is enabled will turn the hood off and cancel the Delay Off Function.

-  Airflow Control Technology (ACT) allows the installer to set the maximum blower CFM to align with local codes and regulations. 

- To verify the maximum blower CFM:
 

- With hood off, hold the      Button for three seconds. The blower CFM will be displayed on the LCD.

  Fan Speed Decrease Button
- Press this button to decrease fan speed. 6 (burst), 5, 4, 3, 2, 1.
- If fan is On Speed 1 and this button is pressed, fan will power Off.
  Fan Speed Increase Button
- Press this button to increase fan speed. Fan On, 1, 2, 3, 4, 5, 6 (burst).
- If hood is Off and this button is pressed, fan will turn On Speed 1.
  Burst Mode
- This speed level is intended to be used as a quick burst of air extraction when excess cooking fumes and smoke are                             
  generated. After 3 minutes the fan will automatically change to Speed 5.

- Lights are two levels, High and Low.
- From off, press one time for High. LCD will show the words “

lights hi

” for 2 seconds then fade away.

- Press again for Low. LCD will display the words “

lights lo

” for 2 seconds then fade away.

- Press again to power lights off.

clean mesh filter

clean air

replace charcoal filter