GE PHP9030SJSS Hoja De Especificaciones

Specification Created 1/15

Listed by 

Underwriters 

Laboratories

To insure accuracy, it is best to make a

template when cutting the opening in the counter

Electrical junction box 16" MIN.

below countertop

Cooktop

29-7/8"

21-1/2"

19-1/4"

28"

19-5/8"

to 19-3/4"

2-1/2" MIN.

Required

28-1/2" to

28-5/8"

1-3/4" MIN.

to rear wall

PHP9030SJ

4-5/8" at baffle near center 

ofunit (except when installed

above an approved wall 

oven) and 3-1/4" at rear 

of air intake

13" MAX. depth of unprotected

overhead cabinets (when no

hood or microwave is installed)

30" MIN. from countertop to

unprotected cabinet (when

no hood or microwave is

installed)

2" MIN. clearance

to side wall from cut-out

on both sides of cooktop

15" MIN. height from countertop

to nearest cabinet (including

light rails) on both sides of

cooktop

Important: Requires a 5" free area between 

the bottom of the cooktop to any combustible 

material, i.e., shelving. Free area not required 
when installing wall oven underneath cooktop. 

Refer to installation instructions. Requires a 15" 
minimum from cooktop to adjacent overhead 

cabinets. Units are furnished with a 48" flexible 
armored cable. 
note: 30" induction cooktops are approved 

for use over select GE 27" and GE 30" Single 
Wall Ovens and Warming Drawers. Refer 

to cooktop and wall oven/warming drawer 
installation instructions packed with product for 
current dimensional data. If installed with a GE 
Telescopic Downdraft System, consult both the 

cooktop and downdraft installation instructions 
packed with product before installing. Cooktop 
gas/electric supply may need to be re-routed to 
install downdraft. The countertop cutout requires 
23-1/2" minimum flat countertop surface and 25" 

minimum total countertop depth. In addition, 

other clearances to front edge of the countertop 
must be considered. Before installing, consult 

installation instructions packed with product for 
 current dimensional data. 
Cutout fIller trIm kIt: A filler trim kit 

is available for use if your countertop cutout 

is larger than the dimension shown, up to 
29-13/16" x 20-7/16". Order JXTR32B for black or 
JXTR32W for white, to reduce the cutout opening 
for installation of this cooktop. These kits may be 
ordered from your GE Dealer. 

DImensIons anD InstallatIon InformatIon (In InChes)

php9030sJ 

 

240V 7.3
208V 6.4

240V 30.8 Amps

†

208V 30.8 Amps

†

Note: Check local codes 

for required breaker size

approxImate CookIng DImensIons