GE PP7030EJES Hoja De Especificaciones

Specification Created 1/15

Listed by 

Underwriters 

Laboratories

To insure accuracy, it is best to make a

template when cutting the opening in the counter

Electrical junction box 16" MIN.

below countertop

Cooktop

29-3/4"

21-3/8"

19-1/4"

28"

19-5/8" to

19-3/4"

28-1/2" to

28-5/8"

CP9530SJ, PP9030DJ, PP7030EJ, JP7030DJ,

JP5030DJ

2-1/2" MIN.

Required

1-3/4" MIN.

to rear wall

13" MAX. depth of unprotected

overhead cabinets (when no

hood or microwave is installed)

30" MIN. from countertop to

unprotected cabinet (when

no hood or microwave is

installed)

15" MIN. height from countertop

to nearest cabinet (including

light rails) on both sides of

cooktop

2" MIN. clearance

to side wall from cut-out

on left sides of unit and

1-1/2" clearance on

right side of unit

3-1/4" at front of unit and

6" at conduit location

Important: Requires a 5" free area between the 

bottom of the cooktop to any combustible material, 
i.e., shelving. Free area not required when installing 

wall oven underneath cooktop. Refer to installation 

instructions. Requires a 15" minimum from cooktop 
to adjacent overhead cabinets. Units are furnished 

with a 48" flexible armored cable. 
note: 30" Ribbon cooktops are approved for use 

over select GE 27" and GE 30" Single Wall Ovens 
and Warming Drawers. Refer to cooktop and wall 

oven/warming drawer installation instructions 
packed with product for current dimensional 

data. If installed with a GE Telescopic Downdraft 
System, consult both the cooktop and downdraft 
installation instructions packed with product before 
installing. Cooktop gas/electric supply may need to 
be re-routed to install downdraft. The countertop 

cutout requires 23-1/2" minimum flat countertop 
surface and 25" minimum total countertop depth. 
In addition, other clearances to front edge of the 

countertop must be considered. Before installing, 

consult installation instructions packed with 
product for  current dimensional data.
Cutout fIller trIm kIt: A filler trim kit 

is available for use if your countertop cutout is 

larger than the dimension shown, up to 29-13/16" x 

20-7/16". Order JXTR32B for black or JXTR32W for 
white, to reduce the cutout opening for installation 
of this cooktop. These kits may be ordered from your 

GE Dealer. 

DImensIons anD InstallatIon InformatIon (In InChes)

pp7030eJ 

9.5

8.2

39.6 Amps

†

39.6 Amps

†

†

note: Check local codes 

for required breaker size

approxImate CookIng DImensIons