Dacor RNR30NI Guía De Diseño

All specifications subject to change without notice.

Phone: (800) 793-0093

www.dacor.com

Document # PG05-011

Revised 01/28/15   Page 4/5

All tolerances +1/16” (+1.6 mm), -0 unless otherwise noted.

1

 To create a “built-in look” on the front of the cabinet, this 

dimension may be changed to 29 1/4” (74.3 cm), with the 

width at the notches remaining 30 1/16”. This configuration is 

only for models RNR30NIS and RNR30NIFS with side panels 

behind door removed.

Countertop height:  34 3/4” (88.3 cm) min.

 

 

36 7/8” (93.7 cm) max.

Countertop thickness: 1 5/8” (4.1 cm) max. 

 

■

The self-rimming installation of the RNR30NI[F]S range creates a 

“built-in” look where the range trim overlaps the countertop on both 

sides and in back.

 

■

Observe all vertical cabinet clearances on page 3/5.

 

■

On self-rimming installations when sliding the range into position, it 

will stop when the rear of the control panel or side panels contact the 

notches toward the front of the countertop.

Rear wall or

countertop edge

countertop opening

29 1/4” (74.3 cm)

30 1/16” (76.2 cm)

cabinet opening

below countertop

below countertop

Cabinet face

Notch countertop

to width of cabinets 

3/8” min. (9.5 mm)

 countertop overhang

1” min. (2.6 cm)

to any combustibles 

above counter both sides

20”

 (50.8 cm)

to

23”

 (58.4 cm)

20”

 (50.8 cm)

Countertop front

Max. 

overhang 

1 5/8”

 (4.1 cm)

Rear wall or

countertop edge

countertop opening

29 1/4” (74.3 cm)

30 1/16” (76.2 cm)

1

cabinet opening

below countertop

below countertop

Cabinet face

Notch countertop

to width of cabinets 

3/8” min. (9.5 mm)

 countertop overhang

1” min. (2.6 cm)

to any combustibles 

above counter both sides

23”

 (58.4 cm)

Max. 

overhang 

1 5/8”

 (4.1 cm)

Countertop front

34 3/4”

 (88.3 cm)

to

36 7/8”

 (93.7 cm)

(see diagrams)

Countertop

1 5/8 (41.1 cm)

max. thickness