GE JP3030DJBB Hoja De Especificaciones

Specification Created 1/15

Listed by 

Underwriters 

Laboratories

Important: Requires a 5" free area between 

the bottom of the cooktop to any combustible 

material, i.e., shelving. Free area not required 
when installing wall oven underneath cooktop. 

Refer to installation instructions. Requires a 15" 
minimum from cooktop to adjacent overhead 

cabinets. Units are furnished with a 48" flexible 
armored cable. 

note: 30" Ribbon cooktops are approved for use 

over select GE 27" and GE 30" Single Wall Ovens 
and Warming Drawers. Refer to cooktop and wall 
oven/warming drawer installation instructions 
packed with product for current dimensional data. 

If installed with a GE Telescopic Downdraft System, 
consult both the cooktop and downdraft installation 
instructions packed with product before installing. 
Cooktop gas/electric supply may need to be re-routed 
to install downdraft. The countertop cutout requires 
23-1/2" minimum flat countertop surface and 25" 
minimum total countertop depth. In addition, other 

clearances to front edge of the countertop must be 
considered. Before installing, consult installation 
instructions packed with product for  current 

dimensional data. 

Cutout fIller trIm kIt: A filler trim kit 

is available for use if your countertop cutout is 

larger than the dimension shown, up to 29-13/16" x 
20-7/16". Order JXTR32B for black or JXTR32W for 

white, to reduce the cutout opening for installation 
of this cooktop. These kits may be ordered from your 

GE Dealer. 

DImensIons anD InstallatIon InformatIon (In InChes)

Jp3030DJ/tJ 

240V 7.4
208V 6.4

240V 30.8 Amps

†

208V 30.8 Amps

†

†

note: Check local codes 

for required breaker size

To insure accuracy, it is best to make a

template when cutting the opening in the counter

Electrical junction box 16" MIN.

below countertop

Cooktop

29-3/4"

21-3/8"

19-1/4"

28"

19-5/8" to

19-3/4"

28-1/2" to

28-5/8"

JP3530DJ_TJ, JP3030DJ_TJ

2-1/2" MIN.

Required

1-3/4" MIN.

to rear wall

13" MAX. depth of unprotected

overhead cabinets (when no

hood or microwave is installed)

30" MIN. from countertop to

unprotected cabinet (when

no hood or microwave is

installed)

15" MIN. height from countertop

to nearest cabinet (including

light rails) on both sides of

cooktop

2" MIN. clearance

to side wall from cut-out

on left sides of unit and

1-1/2" clearance on

right side of unit

3-1/4" at front of unit and

4-3/16" at conduit

location

approxImate CookIng DImensIons