Zephyr ZNAM90CS Manual
10
www.zephyronline.com
Installation –
Mounting the Hood
1
Top Duct Covers
Top Support Frame
Bottom Duct Covers
Bottom Support Frame
5. Remove tape securing electronics mounting bracket to hood and reposition electronics mounting bracket.
),*( ,QVWDOOHOHFWULFDODQGGXFWZRUN$FDEOHORFNQRWVXSSOLHGPLJKWEHUHTXLUHGE\ORFDOFRGHV ),*
( 6HDOGXFWZRUNZLWKDOXPLQXPGXFWWDSH
( 6HDOGXFWZRUNZLWKDOXPLQXPGXFWWDSH
6. Power up hood, verify all functions and check for leaks around duct tape.
$VVHPEOH7RS'XFW&RYHUV ZLWKORXYHUKROHV WRJHWKHURYHU7RS6XSSRUW)UDPHVHFXUH7RS'XFW&RYHUV
together by magnetic strips. Note: If using hood in ductless recirculating mode you must install the air
diverter plate to the Top Support Frame prior to assembling the duct covers. Turn to page 11 for more
details.
diverter plate to the Top Support Frame prior to assembling the duct covers. Turn to page 11 for more
details.
6HFXUH7RS'XFW&RYHUVWR7RS6XSSRUW)UDPHE\XVLQJ [VFUHZV VFUHZVIRUHDFK7RS'XFW
&RYHU ),*'
9. Assemble Bottom Duct Covers together over Top Duct Covers and secure together by magnetic strips.
Bottom Duct Covers should rest on top of the Hood Body.
FIG. D
Cable Lock
Cable Lock
$ FDEOH ORFNLQJ FRQQHFWRU QRW
VXSSOLHG PLJKW EH UHTXLUHG
by local codes. Check with
local requirements and codes,
purchase and install appropriate
connector if necessary.
by local codes. Check with
local requirements and codes,
purchase and install appropriate
connector if necessary.
FIG. E
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
properly grounded. Turn off electrical power at service entrance before wiring.
!
FIG. F