Marvel MA15CRS1RS Manual De Usuario
1.234” (31.3mm)
.991” (25.2mm)
.991” (25.2mm)
NOTE
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
13
Step 6: Drill panel mounting holes
Re-clamp the panel to the door per step 5 and drill the screw
pilot holes for attaching the overlay panel to the door. Select
the size of the hole from Table A. Be careful not to drill the pilot
holes through the overlay panel, (1/2” (12.7mm) deep for 3/4”
(19mm) and 5/8” (15.7mm) panels ).
If your ice machine has a door lock proceed to Step 7. If your
ice machine does not have a door lock proceed to Step 9.
Step 7: Mark and drill lock hole.
Locate and mark with a pencil the location of the lock hole on
the overlay panel, this is the hole in the top corner of the handle
side of the door. Remove the clamp and remove the overlay
panel from the door. On the backside of the panel where you
marked the lock location drill a 13/16” (20.5mm) diameter coun-
ter bore 7/16” (11.0mm) deep into the overlay panel. Drill a 15/32”
(12.0mm) diameter hole through the overlay panel centered on
the counter bore being careful not to splinter the wood on the
face side of the panel. (See Figure 13).
Figure 12
Top hinge
adapter
Hole in hinge
adapter
Door
Overlay
panel
Hole in bottom
hinge adapter
Figure 11
Material Type
#8 Wood Screw
Hardwood
1/8” (3.2mm) Diameter. Pilot Hole
Softwood
7/64 (2.8mm) Diameter. Pilot Hole
Table A