XO XOA30S Manual De Propietario

MAINTENTANCE & CLEAN

1.Disengage the grease pan from the hood body.

2.Disengage the small grease guard cups from the grease guard by turning

counterclockwise and remove.

3.Remove the screw retaining the grease guard to the hood.

4.Remove the grease guard from the hood. Then remove the bottom plate.

5.Unscrew the clips and remove the wheel grease collector.

6.Remove the wheel center cap.

7.Loosen the wheel set screw in order to disengage the wheel from its motor shaft.

Let soak for 30 minutes all removed parts in warm water with soft soap. Then wash with

nylon brush, rinse and dry completely before reinstalling.

HOOD CLEANING

Stainless steel is one of the easiest materials to keep clean. Occasional care will help

preser ve its fine appearance.

Cleaning tips:

* Hot water with soap or detergent is all that is usually needed.

* Follow all cleaning by rinsing with clear water. Wipe dr y with a clean, soft cloth to avoid

water marks.

* For discolorations or deposits that persist, use a non-scratching household cleanser or

stainless steel polishing powder with a little water and a soft cloth.

* For stubborn cases use a plastic scouring pad or soft bristle brush together with

cleanser and water. Rub lightly in direction of polishing lines or “grain” of the stainless

finish. Avoid using too much pressure that may mar the surface.

* Do not allow deposits to remain for long periods of time.

* Do not use ordinar y steel wool or steel brushes. Small bits of steel may adhere to the

surface causing rust.

* Do not allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain

in contact with stainless steel for extended periods. Many of these compounds contain

chemicals that may be harmful. Rinse with water after exposure and wipe dr y with a clean

cloth.

* Painted surfaces should be cleaned with warm water and mild detergent only.

REPLACEMENT PARTS

Light Bulb: Model: XOPXOAB (Type JCD, 12V, 20W Max, G-4 Base)

Replacement Grease Guard: Model: XOPXOAG

NOTE : When reinstalling the wheel, align the end of
the set screw with the flat part of the motor shaft (A).