Maytag MGR8600DS Manual De Propietario

Descargar
Página de 40
15
Oven burner flames are yellow 
or noisy
Range converted improperly
If propane gas is being used, contact a service technician or 
see cover for contact information.
Oven temperature too high or 
too low
Oven temperature needs 
adjustment.
See “Oven Temperature Control” in the “Electronic Oven 
Controls” section.
Convection fan not working
The convection cycle is in the first 
5 minutes of operation.
This is normal. The convection fan will start running 
approximately 5 minutes into the cycle.
Oven door is open.
If the oven door is opened during convention cooking, the fan 
will turn off immediately. It will come back on when the oven 
door is closed.
Display shows messages
Power failure (display shows 
flashing time)
Clear the display. On some models, reset the clock, if needed. 
See “Clock” keypad feature in the “Feature Guide” section.
Error code (display shows letter 
followed by number)
Depending on your model, press CANCEL to clear the display. 
See “Control Display” in the “Electronic Oven Controls” 
section. If it reappears, call for service. See cover for contact 
information.
Start needs to be pressed so a 
cycle can begin (display shows 
“PUSH” or “PSH”).
See the “Start” keypad feature in the “Feature Guide” section.
Range is in Sabbath Mode 
(display shows “SAb”).
Press CANCEL to exit Sabbath Mode.
Clean cycle did not work on all 
spills
Several cooking cycles between 
Clean cycles or spills on oven 
walls and doors
Run additional Clean cycles. Use the AquaLift
®
 Technology 
Cleaning Kit. Use affresh
®
 Kitchen and Appliance Cleaner or 
affresh
®
 Cooktop Cleaner. See the “Accessories” and “Clean 
Cycle” sections for more information.
Mineral deposits are left on the 
oven bottom after the Clean 
cycle
Tap water was used in the Clean 
cycle.
Use distilled or filtered water in the Clean cycle. 
To remove deposits, use a cloth soaked with vinegar. Then use 
a cloth dampened with water to thoroughly remove any vinegar 
residue.
Range is not level.
Mineral deposits will collect on dry areas of the oven bottom 
during the Clean cycle. Level the range. See the Installation 
Instructions.
To remove deposits, use a cloth soaked with vinegar. Then use 
a cloth dampened with water to thoroughly remove any vinegar 
residue.
Oven cooking results not what 
expected
Range is not level.
Level the range. See the Installation Instructions.
The temperature set was 
incorrect.
Double-check the recipe in a reliable cookbook.
Oven temperature needs 
adjustment.
See “Oven Temperature Control” in the “Electronic Oven 
Controls” section.
Oven was not preheated.
See “Baking and Roasting” section.
Racks were positioned 
improperly.
See “Positioning Racks and Bakeware” section.
Not enough air circulation around 
bakeware
See “Positioning Racks and Bakeware” section.
Darker browning of food caused 
by dull or dark bakeware
Lower oven temperature 25°F (15°C) or move rack to a higher 
position in the oven.
Lighter browning of food caused 
by shiny or light colored 
bakeware
Move rack to a lower position in the oven.
Batter distributed unevenly in pan
Check that batter is level in the pan.
Incorrect length of cooking time 
was used.
Adjust cooking time.
Oven door was not closed.
Be sure that the bakeware does not keep the door from closing.
Oven door was opened during 
cooking.
Oven peeking releases oven heat and can result in longer 
cooking times.
Rack is too close to bake burner, 
making baked items too brown 
on bottom.
Move rack to higher position in the oven.
Pie crusts browning too quickly
Use aluminum foil to cover the edge of the crust and/or reduce 
baking temperature.
PROBLEM
POSSIBLE CAUSES
SOLUTIONS