Moen YB5408PB Hoja De Especificaciones
2 5 3 0 0 A L MO E N D R I V E
N O R TH O L MS TE D , O H 4 4 0 7 0
C O R P O R A TE H E A D Q U A R TE R S : ( 8 0 0 ) 3 2 1 - 8 8 0 9
F A X: ( 8 0 0 ) 8 4 8 - 6 6 3 6
I N TE R N A TI O N A L : ( 4 4 0 ) 9 6 2 - 2 0 0 0
F A X: ( 4 4 0 ) 9 6 2 - 2 7 2 6
C U S TO ME R S E R V I C E ( U S A ) : 8 0 0 - 8 8 2 - 0 1 1 6
F A X: ( 8 8 8 ) 3 7 9 - 2 7 2 0
W W W . MO E N . C O M
Copyright Creative Specialties International
.
Paper Holder is constructed of zinc.
YB5408AN
– Paper Holder
Antique Nickel Finish
YB5408AZ
– Paper Holder
Antique Bronze Finish
YB5408BN
– Paper Holder
Brushed Nickel Finish
YB5408CH
– Paper Holder
Chrome Finish
YB5408ORB
– Paper Holder
Oil Rubbed Bronze Finish
YB5408PB
– Paper Holder
Polished Brass Finish
YB5408WR
– Paper Holder
Wrought Iron Finish
Cleaning Instructions:
Stock Number:______________________Paper Holder
By Creative Specialties
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Paper Holder
YB5408
Kingsley
®
Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA1118
1.
Position the mounting template on the wall in the desired location.
Using a level, align the template and tape it to the wall.
Using a level, align the template and tape it to the wall.
2.
Remove each mounting post from the body by loosening the set screw.
3.
Place each mounting post on the template with notch facing down.
4.
Mark the 2 large hole locations of each mounting bracket.
5.
Attach each mounting bracket to the wall, using the wall anchors
provided.
provided.
6.
Mount each base on the corresponding mounting bracket. Check and
make sure that the base set screw hole(s) are facing down. Assemble a
set screw to each base. Use the allen wrench included in hardware kit
to tighten each set screw and secure the assembly to the mounting
bracket(s).
make sure that the base set screw hole(s) are facing down. Assemble a
set screw to each base. Use the allen wrench included in hardware kit
to tighten each set screw and secure the assembly to the mounting
bracket(s).
7.
Tighten all 4 screws. Do not over tighten.
8.
Place each post over the m ounting plate (set screw down). Pivoting
post with bar to be on left side. Tighten both set screws.
post with bar to be on left side. Tighten both set screws.