Franke FF2980 Instruccion De Instalación

Standard Water Flow  2 GPM at 22,5 PSI
Maximum Water Flow 2.2 GPM at 150 PSI
Recommended Pressure Range 22,5 PSI
Complies with NSF61, AB1953, and ASME A112.18.1-2005/CSA B 125.1-2005
Requirements

1

Faucet assembly

2 Rubber 

washer

3

Mounting Shank

4

Rubber washer

5

Plastic flange

6

Shaped washer

7 Fixing 

plate

8

Fixing nut

9

Flexible supply hoses

10 Nipples (not included in US models)
11 Key for aerator

1. Remove all contents from the package and check for completeness.

2. Flush pipe work to ensure it is free from debris.

3. Turn off water supply.

4. Remove faucet and hardware from its protective packaging.
Faucet comes assembled.

5. Connect the 2 flexible supply hoses (9) - red hot water, blue cold
water - to the body of the faucet (1).

6. Cut a mounting hole 1 3/8 diameter (35mm) in the desired position in
counter  top or sink (if one isn’t available).

7. Place the rubber washer (2) over the hole.
ATTENTION: The washer should be sitting between the countertop and
faucet base.
DO NOT use putty or other sealant at this location.

NOTES: 
Solid surface installation: The countertop mounting surface needs to
be flat and free of debris otherwise the faucet may not sit properly.
For tile installations, avoid installing faucet near or on top of grout lines.
This may cause a weak joint between the faucet and the counter and
could cause leaks.

8. Install the monting hardware to the base of the faucet body in
the following order - rubber washer (4); plastic flange (5) shaped
washer (6) and the fixing plate (7) as illustrated.

9 .Tighten the body down installing Fixing Nut (8) to the Mounting
Shank (3).

10. Connect the flexible supply hoses to the water supply in the house
and turn on the faucet. Ensure everything is functioning properly and
check/ test for leak.

2

1

3
4
5

6

7
8
9