Summit SWC530LBISTADA Manual De Propietario
7
To view the SET temperature at any time, press and hold the corresponding
button for approximately 5 seconds. The SET temperature will flash in the LED
display for 5 seconds.
button for approximately 5 seconds. The SET temperature will flash in the LED
display for 5 seconds.
In the event of a power interruption, all previous temperature settings are
automatically erased and each compartment will default to a preset temperature
setting of 43
automatically erased and each compartment will default to a preset temperature
setting of 43
°
F (5
°
C) for the upper compartment and 54
°
F (12
°
C) for the lower
compartment.
This unit may have the option to display temperatures in either Fahrenheit or
Celsius. To change the setting, press and hold both buttons (SET Upper/SET
Lower) simultaneously for approximately 5 seconds. A prompt (beep) will sound
and the blue pilot light adjacent to the
Celsius. To change the setting, press and hold both buttons (SET Upper/SET
Lower) simultaneously for approximately 5 seconds. A prompt (beep) will sound
and the blue pilot light adjacent to the
°
F or
°
C mode will illuminate. (Some
models do not offer this feature).
NOTES
If the unit is unplugged, or turned off, or if there is a power failure, you must
wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this
time delay, the wine cellar will not start.
wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this
time delay, the wine cellar will not start.
When you use the wine cellar for the first time, or restart the wine cellar after it
has been shut off for a long time, there could be a few degrees variation
between the temperature you select and the one indicated on the LED readout.
This is normal and is due to the length of the inactivation time. Once the wine
cellar has been running for a few hours, it should operate normally.
has been shut off for a long time, there could be a few degrees variation
between the temperature you select and the one indicated on the LED readout.
This is normal and is due to the length of the inactivation time. Once the wine
cellar has been running for a few hours, it should operate normally.
Interior Light
You can turn the interior light ON or OFF by pushing the button marked with the
“bulb” symbol
. The light will turn off automatically if it remains ON for 10
minutes. To turn the light back on, push the button marked with the “bulb”
symbol
again. For best storage of wine, keep the light off except when
viewing.
Defrosting
During its operating cycle, the wine cellar defrosts itself every 8 hours.
Defrosting takes about 30 minutes. The water resulting from the defrost is
collected in a drip tray near the compressor where it is automatically evaporated.
During the defrosting operation, the displayed temperature may be higher than
the set temperature.
Defrosting takes about 30 minutes. The water resulting from the defrost is
collected in a drip tray near the compressor where it is automatically evaporated.
During the defrosting operation, the displayed temperature may be higher than
the set temperature.