Dacor ERV48 Guía De Instalación
wARNINgS:
1. Read all instructions before
using the appliance.
2. Install or locate this appliance
only in accordance with these
installation instructions.
3. Use this appliance only for its
intended use as described in
this manual.
4. Do not operate this appliance
if it has a damaged electrical
cord or plug, if it is not
working properly or if it has
been damaged or dropped.
5. This appliance should be
serviced only by qualified
service personnel. Contact the
nearest DACOR Authorized
Servicer at (800) 772-7778,
or at www.dacor.com for
examination, repair or
adjustment.
6. Do not cover or block any
openings on the appliance.
wARNINg:
TO REDUCE ThE RISk OF FIRE,
ELECTRIC ShOCk, OR INJURY
TO PERSONS, OBSERVE ThE
FOLLOwINg:
a) Installation work and
electrical wiring must be
done by qualified person(s)
in accordance with all
applicable codes and
standards, including fire-rated
construction.
b) Sufficient air is needed
for proper combustion
and exhausting of gases
through the flue (chimney)
of fuel burning equipment
to prevent back drafting.
Follow the heating equipment
manufacturer’s guidelines
and safety standards such
as those published by the
National Fire Protection
Association (NFPA), and
the American Society for
heating, Refrigeration and
Air Conditioning Engineers
(AShRAE), and the local code
authorities.
c) when cutting or drilling into
wall or ceiling, do not damage
electrical wiring and other
hidden utilities.
d) Ducted fans must always be
vented outdoors.
e) To reduce the risk of fire, use
only metal duct work to install
raised vents.
f) For general ventilating use
only. Do not use to exhaust
hazardous or explosive
materials and vapors.
wARNINg:
TO REDUCE ThE RISk OF FIRE,
USE ONLY METAL DUCTwORk.
CAUTION:
To Reduce the Risk of Fire And
Electric Shock, Install This
Downdraft Ventilation Unit Only
with Remote Blower Models Rated
Maximum 8 Amp (total of all
interconnected remote blowers).
gROUNDINg INSTRUCTIONS
•
This appliance must be
grounded. In the event of
an electrical short circuit,
grounding reduces the risk of
electric shock by providing
an escape wire for the electric
current. This appliance is
equipped with a cord having
a grounding wire with a
grounding plug. The plug
must be plugged into an outlet
this is properly installed and
grounded.
grounded.
wARNINg:
Improper grounding can result in
a risk of electric shock.
•
Consult a qualified electrician
if the grounding instructions
are not completely
understood, or if doubt exists
as to whether the appliance is
properly grounded.
•
Do not use an extension cord.
If the power supply cord is
too short, have a qualified
electrician install an outlet
near the appliance.
CAUTION:
To reduce risk of fire and to
properly exhaust air, be sure to
duct air outside – Do not vent
exhaust air into spaces within
walls or ceilings or into attics,
crawl spaces or garages”
IMPORTANT SAFETY INSTRUCTIONS