Marvel M36ARWSR Hoja De Especificaciones

24

The condenser is located behind the top grille. It is a part 

of the Power Module on its very right hand side. It has 

horizontal tubes with small diameter vertical wires and it is 

black in color. It is away from floor dust, however, 

essary. Remember to shut off the circuit breaker before 

removing the grille and before exposing, cleaning, and/or 

vacuuming the condenser.

The louvered black or stainless steel grille is all one as-

sembly. There are 3 ways to remove the grille. The most 

widely used method of mounting is with springs. The 

spring(s) are located behind the grille back. The spring(s) 

are mounted to the top of the cabinet and hook to the 

square holes in the grille back. To remove the grille, pull 

the grille forward and reach down to the spring and unhook 

it from the grille back. The grille back will be free to be 

removed.

The second method (optional) is with mounting brackets 

behind the grille back. Pull the grille forward about one (1) 

inch to expose the top screw in the brackets. Unscrew the 

screw to loosen it but do not remove it. Do this to each 

bracket. CAUTION, when the screw is loosened, the grille 

back will be loose, do not allow it to fall. Grasp the grille 

back on each side and tilt the top forward and lift upward to 

free the grille from its mounting.

A custom panel grille can be removed by lifting up on the 

facia panel and pulling forward on the facia panel. The 

grille back is held in place by a screw at the center going 

up into the adjacent cabinet. Remove this screw and the 

grille back can be removed.

The louvered grille is heavy so use care when removing.  

Now you can inspect the condenser for dust accumulation.

Be sure to refasten top grille after cleaning to avoid injury, 

as grille could fall if not properly fastened.

Figure 29

-Condenser

(behind grille)

Power module

(on top of cabinet)-