Dacor ETT3652 Guía De Instalación
3
Below Countertop Preparation
WARNING:
Failure to provide proper
clearances may result in a fire
hazard!
NOTES:
1. Plastic or other utensils with
low melting temperatures
should not be stored in
drawers immediately below
the cooktop.
2. Access to the underside of
the cooktop and the junction
box must be provided for
inspection and service.
All models are designed for standard 24-inch-
deep (610mm) base cabinets with 25-inch
(635mm) overall depth countertops. Before
making the countertop cutout, make certain that
the cooktop will clear the front and side walls
of the base cabinet as shown. Clearance is
required for proper fastening of the cooktop hold
down brackets.
Also allow a minmimum 2-inch (51mm)
clearance between the bottom of the cooktop
chassis and any combustible surface, including
the upper edge of a drawer installed below the
cooktop.
Locate the junction box within reach of the
included 48-inch-long (1219mm) cooktop power
lead such that the junction box is accessible
when the cooktop is in place.
Installing the Cooktop
WARNING:
Do not use a hardening
compound or caulking to
permanently seal the cooktop into
place, as the unit must be readily
removable for service. If such a
hardening compound is used,
removal of the unit will be at the
customer’s expense.
Attach the foam tape provided with the unit to
the underside of the cooktop frame. Place and
center the cooktop within the cutout. Secure the
cooktop to the countertop utilizing the two (2)
hold-down brackets provided. Slide the brackets
into the slots located on the left and right sides
of the chassis, then tighten the screws to the
underside of the countertop.
Glass Top and
Frame
Foam Tape Seal
Countertop
4“ (102mm)
Hold Down Bracket
and Screw
Cooktop Installation
Section View
Electrical Connection
WARNINGS:
1. Ensure that the power supply
is disconnected before
proceeding.
2. Verify that the power supply
matches the ratings found on
the appliance data plate before
proceeding.
3. The complete appliance must
be properly grounded at all
times when electrical power is
applied.
4. Do not ground the appliance
with the neutral (white) house
supply wire. A separate
ground wire must be utilized.
5. If aluminum house supply
wiring is utilized, splice the
appliance copper wires to the
aluminum house wiring using
special connectors designed
and agency-certified for
joining copper and aluminum.
6. Follow the connector
manufacturer’s recommended
procedure carefully. Improper
connection can result in a fire
hazard!
These products are provided with a flexible
conduit consisting of two (2) insulated hot lead
conductors (both copper) and one (1) insulated
ground conductor (copper).
For UL installations attach the conductors to the
residence wiring in accordance with National
Electric Codes and all state, municipal and local
codes.
Verifying Proper Operation
WARNINGS:
1. Never touch any heating
elements when the power is
on.
2. If the cooktop glass is broken,
turn off power to the unit. Do
not operate until glass has
been replaced by a qualified
service technician.
3. This product must be repaired
only by a qualified service
technician. Unit must be
disconnected from power
prior to service.
NOTES:
Before operating the unit:
1. Clean the glass surface
carefully using the Cooktop
Cleaning Creme provided
with the product. Remove all
cleaner residue.
2. Read and understand the
accompanying Use and
Care Manual. Important
safety, service and warranty
information is contained
within the manual.
If all final electrical connections are complete
as indicated, then proceed to turn on the power.
Once the power is on, test each burner position
for correct operation.
Any problems should be reported immediately to
your installer or an authorized Dacor servicer.