Wolf 801641 Manual De Usuario

From inside the wall:



  Drill a 

PILOT HOLE through the wall, 8½" from the inside 

edge of a 

WALL STUD.

From outside - on the wall:



  Measure and mark the 25" x 29½" rectangle. Cut and remove 

only the siding inside this rectangle.



  Measure and mark the 

11" DIAMETER HOLE and  the 1¼" 

DIAMETER HOLE. Cut these holes all the way through the 

wall.

120 VAC

LINE IN

BLACK

TO

BLACK

WHITE

TO

WHITE

GREEN

TO

GREEN



 Remove 

7 COVER SCREWS and lift off ventilator cover. 

Remove 

BIRD SCREEN and WIRING COVER.



  Feed the electric power cable through the 

HOLE and connect cable to ventilator with a proper 

connector for the type of cable being used.



Connect 

BLACK TO BLACK, WHITE TO WHITE, and the 

GREEN TO GREEN or bare wire. Replace wiring cover.



 Remove 

SHIPPING CARDBOARD from blower wheel.



  Place ventilator on wall so that ventilator's discharge collar 

fits into 11" diameter hole.



  Use the 6 screws (provided) to attach the ventilator to the 

wall. 

6 MOUNTING HOLES are provided.



  Seal the screw heads and edges of the flashing sheet with 

a good grade of roofing cement.



  Check for free movement of the spring-loaded damper, 

re-install 

BIRD SCREEN and ventilator cover. Turn on 

power and check operation.