Moen YB0402CH Hoja De Datos Del Producto
YB0402CH
– Swiveling Double Robe
Hook
Chrome Finish
Chrome Finish
YB0402BN
– Swiveling Double Robe
Hook
Brushed Nickel Finish
Brushed Nickel Finish
2 5 3 0 0 A L M O E N D R I V E
N O R T H O L M S T E D , O H 4 4 0 7 0
C O R P O R A T E H E A D Q U A R T E R S : ( 8 0 0 ) 3 2 1 - 8 8 0 9
F A X : ( 8 0 0 ) 8 4 8 - 6 6 3 6
I N T E R N A T I O N A L : ( 4 4 0 ) 9 6 2 - 2 0 0 0
F A X : ( 4 4 0 ) 9 6 2 - 2 7 2 6
C U S T O M E R S E R V I C E ( U S A ) : 8 0 0 - 8 8 2 - 0 1 1 6
F A X : ( 8 8 8 ) 3 7 9 - 2 7 2 0
W W W . M O E N . C O M
Copyright Creative Specialties International
Literature # BA1218
Swiveling Double Robe Hook is
constructed of zinc.
constructed of zinc.
Cleaning Instructions:
Stock Number: YB0402 Swiveling Double Robe Hook
By Creative Specialties
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Swiveling Double Robe Hook
YB0402
ALIGN
™
Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Tools Required: Phillips screwdriver, drill, 1/4” drill bit, hammer, level, tape
Hardware Kit Contents: 2 anchors, 1 hex wrench
Note: Directions below are for installation into drywall. If installing product
into a stud, use the wood screws only.
1) Remove mounting posts from the product assemblies by loosening each
setscrew.
2) Position the mounting plate on the wall in the desired location and mark
holes at the Horizontal screw location on the template if installing into
drywall or vertical screw location if installing into a stud.
3) Drill 1/4” pilot holes in marked locations.
4) Lightly tap anchors until flush with the wall.
5) Place each mounting plate over anchors and insert screws through post
into anchors.
6) Tighten screws.
7) Place posts over the mounting plates with setscrew facing down and
tighten setscrew.
Hardware Kit Contents: 2 anchors, 1 hex wrench
Note: Directions below are for installation into drywall. If installing product
into a stud, use the wood screws only.
1) Remove mounting posts from the product assemblies by loosening each
setscrew.
2) Position the mounting plate on the wall in the desired location and mark
holes at the Horizontal screw location on the template if installing into
drywall or vertical screw location if installing into a stud.
3) Drill 1/4” pilot holes in marked locations.
4) Lightly tap anchors until flush with the wall.
5) Place each mounting plate over anchors and insert screws through post
into anchors.
6) Tighten screws.
7) Place posts over the mounting plates with setscrew facing down and
tighten setscrew.