Frigidaire FDB2410HIS Hoja De Especificaciones
Specifications
subject to change.
Meets
requirements of
ASSE 1006
24" Built-In Dishwasher w/Ready-Select Controls (RSC)
Baseline (FDB2410HI - A.D.A Compliant Model)
Dishwasher Specifications
•
Product Shipping Weight (approx.) – 69 Lbs.
•
Voltage Rating – 120V / 60 Hz / 15 Amps (maximum 20 Amps if
connected with disposer)
•
Connected Load (kW Rating) @ 120 Volts = 1.44 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
•
Amps @ 120V = 10 Amps
•
Always consult local and national electric & plumbing codes.
Meets requirements of ASSE 1006 — integral air gap on supply.
•
Dishwasher enclosure requires that adjacent cabinets be square
and plumb. Unit must be fully enclosed on top, sides and back; and
not support any part of enclosure.
•
For A.D.A. installation, (32 1/2") beneath 34"- high countertop may be
accomplished by adjusting toekick and leveling legs.
•
When installing unit adjacent to wall, cabinet or other obstruction
that extends beyond front edge of unit, allow 2" minimum clearance
between opened door and obstruction.
•
Do not install unit beneath cooktop, damage will occur.
•
Make sure location has required drain, water and electrical outlets
to make proper connections.
•
Air gap required if drain is connected to waste tee or disposer lower
than 18" above floor. If no air gap required, minimum 32"-high drain
loop must be used. Total drain hose length must not exceed 10' to
drain outlet.
•
Electrical and water supplies should enter enclosure on floor, or
through rear or cabinet side walls, as shown in designated shaded
area. Hot water line may pass through same hole as electrical cable
and drain hose; or through additional 1-1/2" dia. hole designated to
accommodate line.
•
Water connection located on left side of dishwasher. Install hot water
inlet line using no less than 3/8" O.D. copper and extend forward at least
18" from rear wall with hand shut-off valve accessible beneath sink.
•
Water Pressure – Hot water line to dishwasher must provide
between 20 and 120 pounds per square inch (psi).
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
USA
•
10200 David Taylor Drive
•
Charlotte, NC 28262
•
1-800-FRIGIDAIRE
•
frigidaire.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
frigidaire.ca
FDB2410HI 05/13
© 2013 Electrolux Home Products, Inc.
Dishwashers
FDB2410HI C / S/ B
24" Built-In