GE JGRP20SENSS Manual De Propietario

Descargar
Página de 28
Control Panel
It’s a good idea to wipe the control panel after 
each use of the oven. Clean with mild soap and 
water or vinegar and water, rinse with clean 
water and polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid 
cleaners, plastic scouring pads or oven cleaners 
RQWKHFRQWUROSDQHO³WKH\ZLOOGDPDJHWKH
finish. A 50/50 solution of vinegar and hot 
water works well.
 
GEAppliances.com
Lift-Off Oven Door
The oven door is removable, but it is heavy. You 
may need help removing and replacing the 
door. Do not lift the door by the handle. This can 
cause the glass to break or can cause damage 
to the door.
To remove the door,
  open it a few inches to 
the special stop position that will hold the door 
open. Grasp firmly on each side and lift the 
door straight up and off the hinges.
NOTES:  
„
  Be careful not to place hands between the 
hinge and the oven door frame as the hinge 
could snap back and pinch fingers.
„
  While working in the oven area, cover the 
hinges with towels or empty paper towel rolls 
to prevent pinched fingers and chipping the 
porcelain enamel on the frame.
To replace the door, make sure the hinges 
are in the special stop position. Position the 
slots in the bottom of the door squarely over 
the hinges. Then lower the door slowly and 
evenly over both hinges at the same time. If the 
hinges snap back against the oven frame, pull 
them back out.
To clean the inside of the door:
„
  Do not allow excess water to run into any 
holes or slots in the door .
„
  Because the area inside the gasket is 
cleaned during the self clean cycle, you do 
not need to clean this by hand. Any soap left 
on the liner causes additional stains when 
the oven is heated.
„
  The area outside the gasket can be cleaned 
with a soap-filled plastic scouring pad.
To clean the outside of the door:
„
  Use soap and water to thoroughly clean the 
top, sides and front of the oven door. Rinse 
well. You may also use a glass cleaner to 
clean the glass on the outside of the door.
„
  Spillage of marinades, fruit juices, tomato 
sauces and basting materials containing 
acids may cause discoloration and should be 
wiped up immediately. When the surface is 
cool, clean and rinse.
„
  Do not use oven cleaners, cleansing powders 
or harsh abrasives on the outside of the door.
Lift the door straight up and off the 
hinges.
The gasket is designed with a gap 
at the bottom to allow for proper 
air circulation.
Do not rub or clean the door 
JDVNHW³LWKDVDQH[WUHPHO\ORZ
resistance to abrasion. 
If you notice the gasket becoming 
worn, frayed or damaged in any 
way or if it has become displaced 
on the door, you should have it 
replaced.
Do not use a steel wool pad; it will scratch  
the surface.
To clean the stainless steel surface, use warm 
sudsy water or a stainless steel cleaner or 
polish. Always wipe the surface in the direction 
of the grain. Follow the cleaner instructions for 
cleaning the stainless steel surface.
To inquire about purchasing stainless steel 
appliance cleaner or polish, or to find the 
location of a dealer nearest you, please call our 
toll-free number:
National Parts Center 
1.800.626.2002
GEAppliances.com
Stainless Steel Surfaces
21