Franke FF7000A Instruccion De Instalación

2. Flush pipe work to ensure it is free from debris.
3. Cut mounting holes 1 3/8" diameter (8” center-to-center spread requirement for 

faucet) in the desired position in sink.

4. Remove faucet and hardware from its protective packaging. Faucet comes 

8. Place the escutcheons (for FF6000) and large 'O'rings (for FF6000 and/or FF7000) 

over the faucet shanks and place the faucet into the desired position.

ATTENTION:  The rubber ‘O’ring should be sitting on top of the countertop and 

between the faucet escutcheons. DO NOT use putty or other sealant at this location.

NOTES:
Solid surface installation: The sub-countertop mounting surface needs to be flat and 

free of debris; otherwise the faucet will not sit properly.

Tile installation: Avoid installations near or on top of grout lines. The faucet will not sit 

secure when sitting on such.

5. Detach hose fittings from tee body, temporarily remove locknut from diverting side.
6. Slide banjo fitting down from its location.
7. Unscrew plastic mounting nuts from the faucet shanks.

9. Assure that the handles and spout are properly aligned in correct positions; spout 

should swivel face forward into sink and handles should point outward parallel with 
bridge faucet. Handles should 1/4" turn towards front of sink (counter-clockwise 
1/4" turn for hot side & clockwise 1/4" turn for cold side).

10. Slide plastic mounting nuts over supply lines. Install the plastic mounting nuts to 

the threaded shanks from underneath the sink.

11. Tighten plastic mounting nuts with required plumbers wrench (1 7/16" size).
12. Slide banjo-divert fitting over the cold side supply lines followed with the thread 

brass locknut into its location. Ensure fitting hose is positioned between both 
shanks and fitting hose turns downwards inline with other supply lines.

13. Tighten threaded brass locknut with required plumbers wrench (1 7/16" size).

*NOTE: Specify color finish when
             ordering replacement parts