KitchenAid KBBR306ESS-SS Guía De Instalación

INSTALLATION 

INSTRUCTIONS

Unpack the Refrigerator

■

Do not remove the film covering until the refrigerator is in its 
operating location.

■

All four leveling legs must contact the floor to support and 
stabilize the full weight of the refrigerator.

■

Keep the cardboard shipping piece or plywood under the 
refrigerator until it is installed in the operating location.

1. Remove and save the literature package bag taped to the 

side of the refrigerator and the parts bag behind the grille. 
Remove the four brackets (two on each side) that attach the 
shipping base to the refrigerator bottom. 

NOTE: Do not remove tape and door bracing until the 
refrigerator is in its final location.

2. If necessary, reduce the tipping radius. See “Tipping Radius” 

for ceiling height requirements or “Reduce Tipping Radius” 
for step-by-step instructions. If you do not need to reduce the 
tipping radius, proceed to “Move the Refrigerator into 
House.”

Reduce Tipping Radius

(if required)

Before bringing the refrigerator into the home, be sure there is 
adequate ceiling height to stand the refrigerator upright. See 
“Tipping Radius” in the “Installation Requirements” section for 
more information.

If you do not have adequate ceiling height to stand the 
refrigerator upright, the tipping radius can be reduced by 
removing the top grille and side trims (see the following chart). 

1. Grasp both ends of the top grille.

2. Push the top grille straight up; then pull straight out. 

Lay the grille on a soft surface.

3. Remove the 6 screws attaching each cabinet side trim to the 

refrigerator and remove the side trims.

Move the Refrigerator into House

1. Place an appliance dolly under the left-hand side of the 

refrigerator as shown. Place the corner posts from the 
packing materials over the trims and handles as appropriate 
to avoid damage. Slowly tighten the strap.

NOTE: Pass the dolly strap under the handles.

36"

89" (226.1 cm)

42"

90" (228.6 cm)

B

B

A