KitchenAid KSF22C4CYY Manual De Propietario

2. Use a 

⁵⁄₁₆" wrench to turn the screw. To raise the refrigerator 

door, turn the screw to the right. To lower the door, turn the 
screw to the left.

3. Check that the doors are even at the top and bottom. If 

necessary, continue to turn the alignment screw until the 
doors are aligned.

4. Replace the base grille.
NOTE: Be sure to refasten the Tech Sheet behind the base grille.

Handle Installation and Removal

PARTS INCLUDED: Door handles (2), 

¹⁄₈" hex key, spare 

setscrew(s)

NOTE: The handle mounting setscrews are preinstalled in the 
handle.
1. Remove the handles, which are packed inside the refrigerator.

NOTE: To avoid scratching the finish, place the handles on a 
towel or other soft surface.

2. Open the freezer door. On the refrigerator door, place the 

handle on the shoulder screws with the setscrews facing the 
freezer.     

3. Firmly push the handle toward the door until the handle base 

is flush against the door. 

4. While holding the handle, insert the short end of the hex key 

into the upper hole and slightly rotate the hex key until it is 
engaged in the setscrew. 

5. Using a clockwise motion, tighten the setscrew until it begins 

to contact the shoulder screw. 

6. Repeat steps 4 and 5 to begin fastening the lower setscrew. 

7. Once both setscrews have been partially tightened as outlined 

in the previous steps, fully tighten both the upper and lower 
setscrews.
IMPORTANT: When the screws feel tight, tighten them an 
additional quarter-turn. The handle is not properly installed 
without this extra tightening.

8. Open the refrigerator door and close the freezer door. Repeat 

steps 2 through 7 to install the other handle onto the freezer 
door with the setscrews facing the refrigerator.

9. Save the hex key and all instructions.

1. While holding the handle, insert the short end of the hex key 

into the lower setscrew hole and slightly rotate the hex key 
until it is engaged in the setscrew.

2. Using a counterclockwise motion, loosen the setscrew a 

quarter-turn at a time. 

3. Repeat steps 1 and 2 for the upper setscrew. Gently pull the 

handle away from the door.

4. If necessary, use a Phillips screwdriver to remove the shoulder 

screws from the door.

Location Requirements

IMPORTANT: This refrigerator is designed for indoor household 
use only.
To ensure proper ventilation for your refrigerator, allow for 

¹⁄₂" 

(1.27 cm) of space on each side and at the top. Allow for 2" 
(5.08 cm) of space behind the refrigerator. If your refrigerator has 
an ice maker, allow extra space at the back for the water line 
connections. When installing your refrigerator next to a fixed wall, 
leave a 2" (5.08 cm) minimum space on each side (depending on 
your model) to allow the doors to swing open.   

A

B