Maytag MEDB725BW Manual De Propietario

Use these buttons to select available options for your 

dryer. Not all cycles and options are available on all 

models.

If you will be unable to remove a load immediately,  

press Wrinkle Prevent to add up to 150 minutes of 

periodic tumbling to help reduce wrinkling. On models 

with Wrinkle Prevent with Steam, a short steam cycle is 

added after 60 minutes to help smooth out wrinkles. 
Drum Light 

Press to turn the drum light on or off. The light will  

also turn on when the door is open, and turn off  

automatically after about 5 minutes. 
Damp Dry Signal 

When selected, a signal will sound during the drying  

cycle when the load is damp but not completely dry. 

This will allow you to take clothes out of the load that 

do not need to dry completely. This option is available 

on Heavy Duty, Normal, Denim, Bulky, Wrinkle  

Control, Sheets, Active Wear, Towels and Delicate 

cycles.
NOTE: The Damp Dry signal defaults to “ON” when  

using the Bulky cycle.
Cycle Signal 

Use this button to turn the signal indicating the  

end of a drying cycle on or off, or to adjust the  

volume of the signal.  
NOTE: You may also turn off the tones that sound 

when a button is pressed. Press and hold the Cycle 

Signal button for about three seconds to turn button 

sounds on or off.
Reduce Static (on some models)

Press to add the Reduce Static option to selected 

Sensor cycles (see Cycle Guide). The dryer will 

automatically tumble, pause, and introduce a small 

amount of moisture into the load to help reduce static. 

This option adds approximately 8 minutes to the total 

cycle time.
Steam Boost (on some models)

Steam Boost adds steam to the end of the Heavy Duty, 

Bulky, Normal, Sheets, Towels, or Denim cycle to help 

smooth wrinkles.

This indicator will show the status of airflow through 

the dryer during Sensor cycles. The Detecting light comes 

on during the sensing phase at the beginning of cycle. 

The Good light will come on if no major vent blockage is 

detected. The Check Vent light will come on if a blocked 

vent or low airflow issue is detected. For more information 

on maintaining good airflow, see “Check Your Vent System  

for Good Airflow”. The Airflow sensing feature is available 

for Sensor cycles only.
NOTE: If there are other error issues during a cycle, the 

Airflow indicator will not light up. See “Dryer Displaying 

Code Message” in “Troubleshooting”section.
Steam (on some models) 

This indicator will light when the Steam function is active.
NOTE: Steam options are not available on all models  

or on all cycles. 
Done 

This will indicate that the selected cycle has ended and 

the load may be removed from the dryer. If the Wrinkle 

Prevent option has been selected, the dryer may continue 

to tumble the load, even if the DONE indicator is lit.  
Check Lint Screen 

The Check Lint Screen indicator will light when the drying 

cycle is complete as a reminder to clean the lint screen. 
Wrinkle Prevent 

This indicator will light if the Wrinkle Prevent option  

has been selected and is running. The dryer will continue  

to periodically tumble the load for up to 150 minutes  

(depending on model and selected settings) after the  

cycle has ended.  

Steam model shown

When you select a cycle, its default settings will light up 

and the Estimated Time Remaining (for Sensor Cycles) or 

actual time remaining (for Timed Cycles) will be displayed. 
Use the buttons along the bottom of the display to adjust 

settings. See “Cycle Guide” for available settings on each 

cycle. Not all settings are available with all cycles.