Alpine IVE-W530 Manual De Propietario
65
-EN
Antenna Receptacle
Video Input Connector (AUX IN) (Yellow)
Input the AUX video.
• To use this function, turn on “AUX1 IN” in the “SETUP” menu (see
Audio Input Connector (AUX IN)
RED is down and WHITE is up input the audio.
Video Output Connector (AUX OUT) (Yellow)
Output the video.
Audio Output Connectors (AUX OUT)
RED is down and WHITE is up output the audio.
Front Output RCA Connectors
RED is left and WHITE is right.
Rear Output RCA Connectors
RED is left and WHITE is right.
Subwoofer Output RCA Connectors
RED is left and WHITE is right.
RCA Extension Cable (sold separately)
Fuse Holder (15 A)
Power Supply Connector
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
amplifier or signal processor.
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna,
if applicable.
if applicable.
• This lead should be used only for controlling the vehicle’s power
antenna. Do not use this lead to turn on an amplifier or a signal
processor, etc.
processor, etc.
Parking Brake Lead (Yellow/Blue)
Connect this lead to the power supply side of the parking
brake switch to transmit the parking brake status signals to
the IVE-W530.
brake switch to transmit the parking brake status signals to
the IVE-W530.
Foot Brake Lead (Yellow/Black)
Connect to the vehicle’s foot brake lead or brake lamp lead.
Remote Control Output Lead (White/Brown)
Connect this lead to the remote control input lead. This lead
outputs the controlling signals from the remote control.
outputs the controlling signals from the remote control.
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s fuse
box or another unused power source which provides (+)
12 V only when the ignition is turned on or in the accessory
position.
box or another unused power source which provides (+)
12 V only when the ignition is turned on or in the accessory
position.
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle’s
battery.
battery.
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
Right Front (+) Speaker Output Lead (Gray)
Right Front (–) Speaker Output Lead (Gray/Black)
Right Rear (–) Speaker Output Lead (Violet/Black)
Right Rear (+) Speaker Output Lead (Violet)
Left Rear (+) Speaker Output Lead (Green)
Left Rear (–) Speaker Output Lead (Green/Black)
Left Front (–) Speaker Output Lead (White/Black)
Left Front (+) Speaker Output Lead (White)
RGB Input Connector
Connect this to the RGB output terminal of the Navigation
System.
System.
USB Connector
Connect this to a Flash Memory device or to an iPod/
iPhone. To use an iPod/iPhone, an iPod interface cable is
required.
iPhone. To use an iPod/iPhone, an iPod interface cable is
required.
• Use the supplied USB cable. If a USB cable other than the supplied is
used, correct performance cannot be guaranteed.
• Route the USB cable away from other cables.
MIC Input Connector
To Microphone
Steering Remote Control Interface Connector
To steering remote control interface box.
For details about connections, consult your nearest Alpine
dealer.
For details about connections, consult your nearest Alpine
dealer.
iPod (V)/AUX Input Connector
Input the iPhone/video compatible iPod audio/video signal
or AUX video/audio signal.
or AUX video/audio signal.
• Set “AUX2 IN” to “iPod Video” in “Setting the AUX Mode”
(page 37) when an iPhone or a video compatible iPod is connected.
• Set “AUX2 IN” to “AUX” in “Setting the AUX Mode” (page 37)
when normal AUX video/audio is input.
CAMERA Input Connector
Use when the optional rearview camera with RCA
Connector is connected.
Connector is connected.
• Set “ON” in “Setting the Rear Camera Input” (page 36) when
connecting a rearview camera with RCA output connector.
Microphone (Included)
Reverse Lead (Orange)
Use only when a back-up camera is connected. Connect to
the plus side of the car’s reverse lamp. This lamp illuminates
when the transmission is shifted into reverse (R).
With this lead properly wired, the video picture
automatically switches to the back-up camera whenever the
car is put into reverse (R).
the plus side of the car’s reverse lamp. This lamp illuminates
when the transmission is shifted into reverse (R).
With this lead properly wired, the video picture
automatically switches to the back-up camera whenever the
car is put into reverse (R).