GE JP3030SJSS Hoja De Especificaciones

JP3030SJ 

 

Specification Created 1/15

Listed by 

Underwriters 

Laboratories

To insure accuracy, it is best to make a

template when cutting the opening in the counter

Electrical junction box 16" MIN.

below countertop

Cooktop

29-7/8"

21-1/2"

19-1/4"

28"

19-5/8" to

19-3/4"

28-1/2" to

28-5/8"

JP3530SJ, JP3030SJ

2-1/2" MIN.

Required

1-3/4" MIN.

to rear wall

13" MAX. depth of unprotected

overhead cabinets (when no

hood or microwave is installed)

30" MIN. from countertop to

unprotected cabinet (when

no hood or microwave is

installed)

15" MIN. height from countertop

to nearest cabinet (including

light rails) on both sides of

cooktop

2" MIN. clearance

to side wall from cut-out

on left sides of unit and

1-1/2" clearance on

right side of unit

3-1/4" at front of unit and

4-3/16" at conduit

location

Important: Requires a 5" free area between  

the bottom of the cooktop to any combustible 

material, i.e., shelving. Free area not required 
when installing wall oven underneath cooktop. 

Refer to installation instructions. Requires a 15" 
minimum from cooktop to adjacent overhead 

cabinets. Units are furnished with a 48" flexible 
armored cable. 
note: 30" Ribbon cooktops are approved for use 

over select GE 27" and GE 30" Single Wall Ovens 
and Warming Drawers. Refer to cooktop and wall 

oven/warming drawer installation instructions 
packed with product for current dimensional 
data. If installed with a GE Telescopic Downdraft 
System, consult both the cooktop and downdraft 

installation instructions packed with product 
before installing. Cooktop gas/electric supply 
may need to be re-routed to install downdraft. 
The countertop cutout requires 23-1/2" minimum 
flat countertop surface and 25" minimum total 

countertop depth. In addition, other clearances to 

front edge of the countertop must be considered. 
Before installing, consult installation instructions 

packed with product for  current dimensional data. 
Cutout fIller trIm kIt: A filler trim kit 

is available for use if your countertop cutout is 

larger than the dimension shown, up to 29-13/16" x 

20-7/16". Order JXTR32B for black or JXTR32W 
for white, to reduce the cutout opening for 
installation of this cooktop. These kits may be 
ordered from your GE Dealer. 

DImensIons anD InstallatIon InformatIon (In InChes)

240V 7.4
208V 6.4

240V 30.8 Amps†
208V 30.8 Amps†

 Check local codes for required breaker size

approxImate CookIng DImensIons