Marvel 24" Digital Refrigerated Drawers - Black Cabinet and Overlay Drawer Fronts Manual De Usuario

Descargar
Página de 20
10
USING YOUR ELECTRONIC CONTROL
Power Failure
Temp
Minus
keypad
Temp
Plus
keypad
On/Off
keypad
Display Area
Lock
keypad
System
Status
indicators
Figure 9
Electronic single zone control
Starting your appliance:
Plug the appliance power cord into a 115 volt wall outlet. 
Your appliance is shipped from the factory in the "On" posi-
tion and will begin start-up of cooling as soon as power is 
supplied. If the appliance does not start, confirm that the 
wall outlet has power, and that the control is in the "On" 
position, (See "Turning your appliance On and Off" below). 
The control display is covered with a clear plastic film. This 
film may be removed by carefully lifting the film at a corner.
On initial power up, the control display will indicate a 
"Power Failure" alarm. This is a normal condition as the ap-
pliance was powered-up at the factory for quality inspection 
and then removed from power. A momentary press of the 
"On/Off" keypad will reset this alarm condition. (See Alarms 
section on page 11).
Turning your appliance ON and OFF:
If the appliance is "On", (and out of sleep mode) the tem-
perature will be shown in the display area of the control. 
To turn the appliance "Off", press and hold the "On/Off" 
keypad for 4-seconds. "OFF" will now be displayed on the 
control.
To turn the appliance "On", press and hold the "On/Off" 
keypad for 4-seconds.
Sleep mode:
If no keypads are pressed for 60 seconds, the display will 
enter sleep mode to conserve power. The control panel will 
go dark with the exception of the system status "OK" indi-
cator which will remain enabled. Alarm conditions will wake 
the display, (see alarms on page 11).
To make the following changes to the control settings 
(turning the appliance ON/OFF, adjusting the tempera-
ture, and activating vacation mode), the control must 
be awake. 
The sleep mode can be disabled if you prefer to have the 
display on continuously. Press and hold the "Lock" key-
pad until the display goes past "Loc" and reads "nSL". To 
enable the sleep mode, repeat the instruction, again going 
past "Loc" until the display reads "SLP".
To wake the display press any keypad. A confirm tone will 
sound, and the current storage compartment temperature 
will be displayed. 
ALARM RESET