Marvel 24" Digital Refrigerated Drawers - Black Cabinet and Overlay Drawer Fronts Manual De Usuario
6
!
CAUTION
!
CAUTION
NOTE
Anti-Tip Device
If your drawer refrigerator is not located under a counter top
(free standing), you must use an anti-tip device installed as
per these instructions. If the drawer refrigerator is removed
from its location for any reason, make sure that the device
is properly engaged when you push the drawer refrigerator
back into the original location. If the device is not properly
engaged, there is a risk of the drawer refrigerator tipping
over, with the potential for property damage or personal
injury.
If installing on concrete floor, concrete fasteners are re-
quired, (not included with the anti-tip kit).
Any finished flooring should be protected with appropriate
material to avoid damage when moving the unit.
Floor Mount Installation
The anti-tip bracket is to be located on the floor in the left
or right rear corner of the refrigerator drawer as shown in
Figure 5.
Step by step instructions for locating the po-
sition of the bracket:
1) Decide where you want to place the drawer refrigerator.
Slide it into place, being careful not to damage the floor,
leaving 1" (2.5 cm) of clearance from the rear wall to allow
room for the anti-tip bracket.
2) Raise the rear leveling legs approximately
1
⁄
4
" (6 mm) to
allow engagement with the anti-tip bracket. Level the unit
by adjusting all the leveling legs as required. Turning the
leveling leg counterclockwise will raise the unit and clock-
wise will lower the unit.
3) Make sure the refrigerator is in the desired location, then
mark on the floor the rear and side corner of the cabinet
where the anti-tip bracket will be installed. If the installation
does not allow marking the rear corner of the cabinet, then
make temporary lines on the floor marking the front corner
of the cabinet, excluding the drawer. Slide the refrigerator
out of the way. From the temporary line extend the sidewall
line back 21
1
⁄
2
" (54.6 cm) as shown in Figure 6.
4) Align the anti-tip bracket to the marks on the floor so
the side of the bracket lines up with the side of the cabinet
mark, and the "V" notches on the anti-tip bracket line up
with the end of the 21
1
⁄
2
" (54.6 cm) line (Rear of cabinet
line).
5) Fasten the anti-tip bracket to the floor using the supplied
screw. (See Figure 6).
6) Slide the cabinet back into position, making sure the rear
cabinet leveling leg slides under the anti-tip bracket engag-
ing the slot.
Bottom View of
Refrigerated
Drawer Unit
Anti-Tip
Bracket
Leveling Leg
Front of cabinet
21
1
⁄
2
"
(54.6 cm)
Figure 5
INSTALLING THE ANTI TIP DEVICE
!
WARNING
• ALL APPLIANCES CAN TIP
RESULTING IN INJURY.
• INSTALL THE ANTI-TIP
BRACKET PACKED WITH
THE APPLIANCE.
• FOLLOW THE INSTRUC-
TIONS BELOW