Electrolux E36WV60PPS Manual De Propietario

Blower Motor Systems Installation

For recessed bottom cabinet only
If the cabinets have front, side or back trim, make 2 
wood shims the width of the trim and attach them to 
the cabinet bottom recess on both sides.

 
Installation to wall
(Horizontal duct– 3

1

⁄

4

”x 10” Rectangular)

 

Use the diagram or the hood as a template and 

 

mark the locations on the wall for ductwork,  

 

electrical wiring and keyhole screw slots.

13-5/6” (30” Hood)

16-13/16” (36” Hood)

1-3/16”

21/32”

13-5/6” (30” Hood)

16-13/16” (36” Hood)

6-13/16” (30”Hood)

6-1/2” (30” Hood)

14-3/16” (36” Hood)

 (30” Model)

 (36” Model)

7” (36” Hood)

7” (36” Hood)

6-13/16” (30”Hood)

permanent 

mounting hole 

permanent 

mounting hole 

Center line 

 

If drywall is present, mark the screw hole  

 

locations. Remove the template.

 

Cut away enough drywall to expose 2 vertical 

 

studs at the holes location indicated by the 

 

template. Install two horizontal supports at least  

 

4” x 2” between two wall studs at the bottom and  

 

upper mounting holes installation location.

 

The horizontal support must be flush with the 

 

room side of the studs. Use cleats behind both 

 

sides of the support to secure to wall studs.

 

Reinstall drywall and refinish.

IMPORTANT- Framing must be capable of supporting
100 lbs.

Centerline of

 

Installation 

Space

View From

 

Cleats

1” x6” Min.

Mounting 

Support

8-1/2” min. opening for ductwork

Rear

 

Cut holes at marked locations for duct and  

 

electrical wiring.

 

For the vertical duct, cut out 

3

⁄

4

” extra toward the 

 

front of the cabinet so you can move the duct  

 

freely when installing the hood.

 

It may also ease installation by cutting the hole 

 10

1

⁄

2

” instead of 10”.

 

Drive a mounting screw (from the hardware 

 

packet) partway into each center of the narrow 

 

neck of the keyhole slots marked on the cabinet 

 bottom.

 

Fix the wiring conduit to the hood.

 

 Slide the hood back against the wall. Tighten the 

 

mounting screws. Be sure the screw heads are in 

 

the narrow neck of the keyhole slot.

 

Connect Ductwork to hood.