Electrolux EW30GC55GS Manual De Propietario

Solutions to Common Problems

iMPortaNt

before calling for service, review this list. it may save you both time and expense. this list

includes common experiences that are not the result of defective workmanship or material

in your cooktop.

suRface buRneRs do not liGHt

• Surface Control knob has not been completely turned to LITE. Push in and turn

the Surface Control knob to LITE until burner ignites and then turn control knob to

desired flame size.

• Be sure gas supply valve is open.
• Burner ports are clogged. Clean burners. See

Cleaning the Burner Grates, Burner

Caps, Burner Heads in General Care & Cleaning section. With the burner off, clean

ports with a small-gauge wire or needle.

• Power cord is disconnected from outlet (Electric Ignition Models only). Be sure cord

is securely plugged into the outlet.

• Electrical power outage (electric ignition models only). Burners can be lit manually.

See

Setting Surface Controls in this Use and Care Guide.

buRneR flaMe only liGHts Half Way aRound
buRneR

•

Burner ports are clogged. With the burner off, clean ports by using a small-gauge

wire or needle.

•

Moisture is present after cleaning. Lightly fan the flame and allow burner to operate

until flame is full. Dry the burners thoroughly following instructions in the General

Cleaning section.

buRneR flaMe is oRanGe

• Dust particles in main line. Allow the burner to operate a few minutes until flame

turns blue.

• In coastal areas, a slightly orange flame is unavoidable due to salt air.