Electrolux EIFLS60JIW Instruccion De Instalación

Excessive noise and vibration can be prevented by 
properly leveling the washer.

For free standing installation and with the 

1. 

washer within 4 feet (1 m) of its fi nal location, 
place a level on top of the washer. 
Use the universal wrench to adjust the level-

2. 

ing legs so the washer is level front-to-rear and 
side-to-side, and stable corner-to-corner.
Press down on alternate corners and sides and 

3. 

feel for the slightest movement.  Adjust the 
appropriate leg(s) so the washer sits solidly on 
the fl oor on ALL four legs.  Keep the leveling leg 
extension at a minimum for best performance 
of the washer.

For pedestal installations, see additional 
installation instructions included with the pedestal.

Run some water from the hot and cold faucets 

1. 

to fl ush the water lines and remove particles 
that might clog the water valve screens and to 
determine which faucet is hot and which is cold 
supply.
Look in the end of each water supply inlet hose 

2. 

and verify that the rubber washers are in place.

Connect the HOT inlet hose to the HOT water 

3. 

supply and the COLD inlet hose to the COLD 
water supply. Tighten by hand until snug.
Tighten each supply connection another 2/3 

4. 

turn with pliers. Do not bend, kink or pinch 
water inlet hoses.

Turn on the water and check for leaks.

5. 

HOT and COLD water inlet hoses are color 
coded for identifi cation. The HOT inlet hose is 
marked with a RED band and the COLD inlet 
hose is marked with a BLUE band.

RUBBER WASHERS
MUST BE PRESENT