Philips BM50B/10 Manual De Usuario
8
EN
Prepare the remote control
Caution
•
Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
To insert the remote control battery:
1
Open the battery compartment.
2
Insert the supplied AAA battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Set clock
1
In standby mode, press and hold CLOCK
on the remote control for 3 seconds.
»
The [24H] or [12H] hour format is
displayed.
2
Press / (or +/-) to select the [24H]
or [12H] hour format.
3
Press CLOCK to confirm.
»
The hour digits are displayed and begin
to blink.
4
Press / (or +/-) to select hour and
press CLOCKto confirm.
»
The minute digits are displayed and
begin to blink.
5
Press / (or +/-) to select minute
and press CLOCK to confirm.
»
‘SYNC OFF’ is displayed.
6
Press / (or +/-) to select ‘SYNC
ON’ or ‘SYNC OFF’ and press CLOCK to
confirm.
»
If you have selected ‘SYNC ON’ ,
automatic clock synchronization starts
when you listen to an RDS station that
transmits time signals.
Tip
•
You can press CLOCK to view clock information when
the unit is switched on.
Turn on
• Press .
»
The unit switches to the last selected
source.
»
The signal strength indicators flash for
several seconds until the unit boots up.
Switch to standby mode
• Press again to switch the unit to standby
mode.
»
The clock (if set) is displayed on the
panel.
Switch to ECO mode:
• Press and hold for more than 3 seconds.
»
The display panel is dimmed.
Note
•
In single mode, the unit switches to ECO mode after
15 minutes in standby mode.
•
In group mode, the unit does not go to ECO mode
automatically.
To switch between standby mode and ECO
mode:
• Press and hold for more than 3 seconds.