Philips DCB310/05 Manual De Usuario
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock!
electric shock!
No sound
– Volume not adjusted.
• Adjust the volume.
• Adjust the volume.
Display error / no reaction to any controls
– Electrical malfunction.
• Press the RESET hole on the bottom of the set with a ball-pen.
Intermittent crackling sound during FM reception
– Weak signal.
• Extend and position the FM/DAB pigtail antenna.
• Extend and position the FM/DAB pigtail antenna.
The alarm does not function
– Alarm time/ mode not set.
• See SETTING THE ALARM TIME.
– Volume too low for radio.
• Increase the volume.
• See SETTING THE ALARM TIME.
– Volume too low for radio.
• Increase the volume.
The indication “No station available” is displayed.
– DAB coverage is currently not available in your area.
• Wait until the coverage resumes.
– DAB signal is weak.
• Re-locate the set, or adjust the position of FM/DAB pigtail antenna.
– DAB coverage is currently not available in your area.
• Wait until the coverage resumes.
– DAB signal is weak.
• Re-locate the set, or adjust the position of FM/DAB pigtail antenna.
The indication “Station off air” is displayed.
– The station is currently out of service.
• Wait until the service resumes. Or, perform a scan by pressing AUTO-SCAN in
– The station is currently out of service.
• Wait until the service resumes. Or, perform a scan by pressing AUTO-SCAN in
DAB mode.
Poor reception
– Signal strength is weak.
• Re-locate the set, or adjust the position of the FM/DAB pigtail antenna. For
– Signal strength is weak.
• Re-locate the set, or adjust the position of the FM/DAB pigtail antenna. For
DAB, you may also perform manual tuning. See Manual tune.
I cannot hear the DAB station I have selected.
–
–
2; button was not pressed after changing a station by pressing TUNING +/-.
• Press
2; button to confirm the selection.
Note:
In case of malfunciton due to electrostatic discharge, just reset the product
(Reconnection of power source may be required.) to resume normal operation.
In case of malfunciton due to electrostatic discharge, just reset the product
(Reconnection of power source may be required.) to resume normal operation.
DCB310_05_CCR 6/27/08 15:33 Page 10