Philips CAW7740N/05 Manual De Usuario

Configuring the Wireless Router

9

Use this page to change the password for accessing the management 
interface of the Wireless Router.

Passwords can contain from 3~12 alphanumeric characters and are case 
sensitive.

If you lost the password, or you cannot gain access to the user interface, 
press the reset button on the rear panel, holding it down for at least five 
seconds to restore the factory defaults. By default, there is no password 
to login to the user interface.

When you reset the Wireless Router using the reset button, all 
configuration settings will be lost, also your ISP setting (Internet Service 
Provider).

Enter a maximum Idle Time Out (in minutes) to define a maximum 
period of time for which the login session is maintained during inactivity.
If the connection is inactive for longer than the maximum idle time, it 
will perform system logout, and you have to log in again to access the 
management interface. (Default: 10 minutes)

By default, management access is only available to users on your local 
network. However, you can also manage the Wireless Router from a 
remote host by entering the IP address of a remote computer on this 
screen. Check the Enabled check box, and enter the IP address of the 
Host Address and click "SAVE SETTINGS".

If you check Enable and specify an IP address of 0.0.0.0, any remote host 
can manage the Wireless Router.

For remote management via WAN IP address you need to connect 
using port 8080. Simply enter WAN IP address followed by :8080, for 
example, 212.120.68.20:8080.

The router can be connected to your Internet Service Provider (ISP) in 
any of the following ways:

- Dynamic IP Address

- PPPoE

- Static IP address

This page allows you to obtain an IP address automatically from your 
Service Provider.

PPPoE is a common connection method used for xDSL.