Cisco Systems OL-16447-01 Manual De Usuario
C-1
Cisco ME 3400E Ethernet Access Switch Hardware Installation Guide
OL-16447-01
A P P E N D I X
C
Configuring the Switch with the CLI-Based
Setup Program
Setup Program
This appendix provides a command-line interface (CLI)-based setup procedure for a standalone switch.
Before connecting the switch to a power source, review the safety warnings in
Before connecting the switch to a power source, review the safety warnings in
and
Accessing the CLI Through the Console Port
You can access the CLI on a configured or unconfigured switch by connecting the console port of the
switch to the serial port on your PC or workstation and accessing the switch through a Telnet session.
switch to the serial port on your PC or workstation and accessing the switch through a Telnet session.
Starting the Terminal-Emulation Software
Before you power on the switch, start the terminal emulation session so that you can see the output
display from the power-on self-test (POST).
display from the power-on self-test (POST).
The terminal-emulation software—frequently a PC application such as Hyperterminal or
ProcommPlus—makes communication between the switch and your PC or terminal possible.
ProcommPlus—makes communication between the switch and your PC or terminal possible.
Follow these steps to start a terminal-emulation session:
Step 1
Start the terminal-emulation program if you are using a PC or terminal.
Step 2
Configure the baud rate and character format of the PC or terminal to match these console port default
characteristics:
characteristics:
•
9600 baud or 115200 baud (suggested rate)
•
8 data bits
•
1 stop bit
•
No parity
•
None (flow control)