Cascade 3V Manual De Usuario

4

CASCADE SPEAKER SYSTEMS

A

SSEMBLY

It is strongly recommended that two people assemble the speakers
to minimize the possibility of damage or injury.

Installing Spiked Feet (Model Nine and Model Seven)

1. Open spike kit and locate the following items: feet (with spike/round

ends), four locking nuts, four nylon domes and one wrench.

2. Lay each stand on its side and locate the four threaded holes on the 

bottom of the base.

3. For carpets, screw the round end of a foot into each hole and fully hand-

tighten a nut onto each one. For hard-surface floors, screw the spike end
into each hole instead and leave the rounded end exposed.

4. Carefully flip each base upright to sit on its feet.
5. If needed, adjust the feet so each speaker is level and then tighten each

nut with the enclosed wrench.To protect hard surfaces (e.g., wood floors),
slip a nylon dome onto each round end.

Note:

Spiked feet must be fully threaded into holes provided in the base 

to ensure stability.

This cross section shows how to install the spikes onto the bottom of a
Cascade Model Nine and Model Seven.

Model Nine and Model Seven

1. Remove floor 

stand from carton.

2. Slide loud-

speaker onto 
stand, making 
sure the aligning 
posts are lined up 
with the receiver 
terminal cup.

3. Insert #8 pan-

head screw into 
rear of speaker to 
secure to stand.

Model Three V

1. Remove base from carton.

2. Securely fasten one cleat to 

the middle set of holes  
on the rear of the speaker 
using two included 
1/4"-20 panhead screws.

3. Slide speaker with 

cleat over the base.

Model Five

1. Remove base 

from carton.

2. Securely fasten one cleat 

to the set of holes above 
the terminal using two 
included 1/4"-20 
panhead screws.

3. Slide speaker 

with cleat over 
the base.

Round End

Spike End

(included for use

on wood floors)

5/8" min.

1-1/8" max.

5/8" 

Cascade OM  8/22/05  10:51 AM  Page 6