Fisher & Paykel ADN20x30 Manual De Usuario
DCS BY FISHER & PAYKEL ACCESS DOORS ADN
INStALLAtION INStRuCtIONS
ACCESS DOOR SPECIFICAtIONS:
MODEL: ADN20x30
MODEL: ADN20x24
SIDE VIEW
MODEL: ADN20x36
35-15/16”
30”
24”
MODEL: ADN20x48
47-15/16”
1-1/4”
4-1/4”
2”
21-7/8”
21-7/8”
5/16”
15/16”
2-1/8”
Anchor hole
(Ø 1/4”)
A
90º
B
Vent*
Vent*
Vent*
CutOut SPECIFICAtION
ACCESS DOOR
MODELS
A
(-0”, +1/8”)
B
(-0”, +1/8”)
ADN20x48
46"
20”
ADN20x36
34"
20”
ADN20x30
28"
20”
ADN20x24
22"
20”
INStALLAtION INStRuCtIONS
Slide frame into opening (see cutout dimensions in chart above).
1.
Check for proper alignment.
2.
Using the four slotted holes in the frame as a guide, pre drill four pilot holes on the left & right sides of
3.
your island. Secure the unit using screws and anchors suited for the type of cabinet material.
Install the access door and check for proper alignment of doors and frame.
Install the access door and check for proper alignment of doors and frame.
4.
NOTE: The cutout of each corner should be 90° angle in order for the access doors to fit properly.
* Island installation to use minimum of 3 vents providing 10 sq. in. per vent (typical).