Graco 1750296 Manual De Usuario

3

• This product is NOT a substitute for direct 

supervision of your baby. Check your baby’s 

activities at regular intervals. Monitoring of 

premature babies, or those considered to be 

at risk, should always be carried out under 

the supervision of a health professional.
• Always place both the Nursery Unit and 

Parents’ Unit on a flat surface in an upright 

position and allow for proper ventilation. 
• Avoid damage to the Sensor Pad cord and 

to the adapter cords. Route cords so that 

they are not likely to be walked on or pinched 

by items placed on or against them.
• Route sensor pad cord only below crib 

matress and out of reach of children.
• Use ONLY AAA (LR03) batteries (not 

included) and/or the AC adapters provided for 

the Parents’ Units.
• During long periods of non-use remove all 

batteries from their compartments and unplug 

the AC adapters.
• This monitor uses public airwaves to 

transmit signals. The Parents’ Unit may pick 

up signals or interference from other nursery 

monitors in your area. Your monitor may even 

be picked up by other households. To protect 

your privacy, make sure both units are turned 

off when not in use. If you experience 

 interference, change the channel on both 

units.
• When the monitor is in use, do not use a 

crib mobile or other crib accessories that may 

produce vibrations. Other sources of  

vibrations may include fans, washing  

machines, loud music, etc. These sources of 

vibration may interfere with the performance 

of your Angelcare® monitor and the alarm 

will not sound if it continues to detect any 

movement other than your baby’s. Be sure all 

vibration sources are eliminated before using 

the monitor.

•  You may experience false alarms for 

several reasons. The most common reason is 

the Nursery Unit has not been turned off after 

you have removed your baby from the crib. 

Another reason is the Sensor Pad has not 

been placed under the mattress properly. Be 

sure the Sensor Pad is on a flat, firm surface 

with the turquoise side facing up.  

The sensitivity level may also need to be 

adjusted. Refer to the Movement Sensitivity 

Adjustment section on Pg. 11.
• Always be sure to immediately check on 

baby whenever an alarm sounds.
•  Your monitor can be used in any crib that is 

stationary and designed to safely hold a baby. 

If your crib has a spring or slat base you will 

need to place a piece of Masonite board  

under the Sensor Pad. This support must be 

at least 13 inches long on all four sides and 

1/4 inch thick. Only use your Angelcare® 

monitor in a stationary sleeping environment 

such as a crib where the Sensor Pad can rest 

on a completely flat, firm surface.