Adams CFW 150 Manual De Usuario

dEC1

Selects the decimal point position
(Options: 0, 0.0, 0.00, 0.000).

C 0.00

InC

Selects the increment size.
(Options: 1, 2, 5 and 10).

inC 10

CAP

Sets the scale capacity. The maximum value
for the scale is as specified for the scale. For
example 60kg.

P2 CAL

CAL

Starts the calibration procedure. See the
details of calibration procedure in section 10.

The sub-parameter “

P3 Pro” is used to view the calibration constant used by the

scale, view the A/D counts and set the scale back to default settings. This is
useful if it is not possible to have a good calibration of a scale. It will show the
load cell is causing the A/D to increment correctly through the complete range of
weights needed and you can recall the default settings for the scale. The “

trl”

value can be modified to cause the scale calibration to change to a known
amount without the need for putting weights on the scale.

trl

Display will show a value that corresponds to
the load cell calibration. If the value is
increased the scale calibration will be
decreased a similar percentage.

CoUnt

Display will show the counts from the A/D
converter. The displayed count should
increase as the weight is added to the load
cell up to and exceeding the capacity of scale.
Typical range for these counts are:
No load 20,000
Maximum 120,000

P3 Pro

rESEt

Scale will reset to factory default settings.
Press [Zero/Enter] to continue or [Print/Esc]
to abort.