Century PM-1863AB Manual De Usuario

Descargar
Página de 32
Remove harness system (see “Harness System -
removal and re-assembly” section).
Place child in car seat with child’s back flat 
against back of car seat.
Place shoulder belt across child’s chest and 
lap belt under both armrests.
Buckle belt and pull shoulder belt to adjust lap
belt snugly.
Shoulder belt MUST lay across child’s shoulder 
in red zone as shown (fig. b).  If outside of
red zone, see next steps for Comfort Clip use.
CAUTION:
Some shoulder belts with (emergency 
locking) retractors allow a child to pull belt 
out and change position of belt.  Use of 
Comfort Clip helps prevent child from 
pulling belt out.
Thread shoulder belt through Comfort Clip
exactly as shown (fig. c).
Check to be sure shoulder belt is properly
positioned over shoulder in red zone and snug 
against child.
To prevent serious injury or death:
• Shoulder belt MUST be properly 
positioned over shoulder (NOT 
touching child’s neck and NOT low 
off shoulder).
• Lap/shoulder belt MUST be properly 
positioned exactly as shown in 
illustration with lap belt under both 
armrests and shoulder belt over one 
armrest.
• DO NOT use shoulder belt loose or 
positioned under child’s arms or 
armrests (fig. a)
.
• Never use a vehicle “lap-only” belt 
across front of child.
• DO NOT allow child to slide down in
car seat which could position lap belt
across child’s abdomen and shoulder
belt over neck or face.
If child will not keep vehicle shoulder 
belt properly positioned, DO NOT use 
this booster car seat.  Use a different 
child restraint system.
• Vehicle belts MUST lay flat against child 
and MUST not be twisted.
1
2
3
4
10
PLACING CHILD IN CAR SEAT 
without
harness system
WARNING
5