GTO RB909 Manual De Usuario

10

Step 1.  Turn control box power switch OFF and unplug the transformer or disconnect the solar panel.  Remove

 

 control box cover and disconnect battery lead wires from the battery terminals before wiring the lock

 

 board to the opener control board.

Step 2.   Connect the WHITE wire (included) to Terminal #1 on the lock board.  Connect the RED battery lead

 

 wire (included) to Terminal #5 on the lock board.  

Step 3.  Attach the RED control board battery lead wire to one spade tongue on a double spade tongue connector 

(included).  Attach the BLACK control board battery lead wire to one spade tongue on the other double 

spade tongue connector (included).

Step 4.  Pull RED and BLACK wires from gate lock through the strain relief and into the control box.  Attach 

BLACK wire to Terminal #3 on lock board. Attach RED wire to Terminal #4 on lock board (see Lock 

). 

Step 5.  Attach RED lock board battery lead wire to the double spade tongue terminal with the RED control 

board lead wire.  Attach the BLACK lock board battery lead wire to the double spade tongue connector 

with the BLACK control board Lead Wire.

Step 6.  Connect the WHITE wire from the lock board directly to the FIRST OPERATOR terminal block along 

with the power cable wire from the opener arm.  Connect the WHITE wire to the BLACK terminal for 

a Pull-to-Open installation or connect WHITE wire to the RED terminal for a Push-to-Open installation  

(see illustration on page 11).

Step 7.  Reconnect opener to gate bracket. Connect the BLACK Battery lead wire (included) to Terminal #2 on 

the lock board. (See Lock Board Wiring Chart below). Connect RED wires (with double spade tongue 

terminal) to POSITIVE (+) battery terminal and the BLACK wires (with double spade tongue terminal) 

to the NEGATIVE (–) battery terminal.  Plug the transformer in or rewire the solar and turn the control 

box power switch ON. Test opener and lock to make sure it functions properly and make adjustments if 

necessary.

RED Wire To Battery

Positive (+) Terminal

RED Wire From Lock 

BLACK Wire From Lock

WHITE Wire to

BLACK on OperatorTerminal

BLACK Wire To Battery 

Negative (–) Terminal

1 2 3 4 5

Time 

A

d

j

* Place a dab of petroleum 

jelly on the terminal con-

tacts to prevent corrosion.

NOTE: It is recommended that the time adjustment knob is turned all the way to the right.