Furuno 1712 Manual De Usuario

 

 

1.  Remove mounting hardware at the bottom 

of the antenna unit; four each of hex bolts 
(M10X20), spring washers and flat washers. 
Save mounting hardware to use it to fix the 
antenna unit to the mounting platform later 
on.  

Flat washer

Spring washer
Hex bolt (M10 x 20)

Screws

two screws on other side

Bow

Stern

 

2.  Construct a platform (wood, steel, or 

aluminum) of 5–10 mm in thickness 
referring to the outline drawing at back of 
this manual. Fasten the platform to the 
mounting location. Next, position the base 
so the cable entrance faces the stern 
direction. 

Note: When drilling holes in the platform, 
be sure they are parallel with the fore and 
aft line. 

3.  Using the hex bolts, flat washers and 

spring washers removed at step 1, fasten 
the base to the platform. The torque 
should be between 19.6-24.5 N

••••

m. 

Note: Longer hex bolts (M10X25) are 
supplied with the installation materials. Use 
them instead of the hex bolts removed 
earlier if the mounting platform is very thick.   

Flat

washer

Antenna base
assy.

Spring

washer

Platform

Hex bolt
(M10 x 25
or M10 x 20)

Transceiver
module

  5-10
10-15

mm: M10x20
mm: M10x25

4.  Unfasten four screws to remove the cover. 

Discard the packing material in the 
radome. 

Remove and discard 
the packing material.

Snap holder

 

The mounting base is fitted with a snap 
holder. which may be used to hang the 
cover after removal. Use the hole next to 
screw hole inside the cover to hang it. 

a)  Unfasten the snap assy. with the string 

attached at the holder in the mounting 
base. 

b)  Unwind the string. 

c) 

Attach the snap to a screw hole on the 
inside of the cover. 

Note: Do not hang any other objects with the       
      snap. 

5.  Unfasten the cable of the rotation detector 

from the cable clamps. 

6.  Unfasten 11 screws to dismount the shield 

plate. Discard screw marked with 

 in the 

Figure 6.