Furuno NAVpilot-700 Manual De Usuario

Descargar
Página de 103
5.  MAINTENANCE, TROUBLESHOOTING
5-3
5.3.2
Processor unit test
This test checks the processor unit for correct operation. Open the diagnostic test op-
tions window, select [PROCESSOR UNIT] then push the Course control knob. The 
results for the ROM, RAM and RUDDER ANGLE are shown as OK or NG. If NG ap-
pears, repeat the test. If the error condition continues, contact your dealer. 
[ROM]: "OK" for normal, program number
[RAM]: RAM test, "OK" for normal
[BACKUP]: Backup data test, "OK" for normal.
[RUDDER ANGLE]: "OK" for normal, actual rudder angle.
[BYPASS/CLUTCH]: Bypass/clutch amperage. ("NOT PRESENT" shown in case of 
no connection.)
[RC1/RC2]: Remote controller state (ON or OFF) and rudder signal input value. "NOT 
USED" shown in case of no connection.
[INPUT VOLTAGE]: Voltage.
[PORT1/PORT2/CAN]: I/O test for PORT1/PORT2/CAN (CAN bus). OK for normal.
[CAN ID]: ID of CAN bus equipment.
5.3.3
Control unit test
This test checks the control unit for correct operation. Open the diagnostic test options 
window, select [CONTROL UNIT] then push the Course control knob. The results for 
[ROM], [RAM], [BACKUP], and [COMMUNICATION] are shown as OK or NG (No 
Good). If NG appears, repeat the test. If the error condition continues, contact your 
dealer.
ROM: OK 
6454007-**.**
 6454009-**.**
RAM: OK  BACKUP: OK
RUDDER ANGLE: OK  0
°
BYPASS/CLUTCH: 0.7A
RC1/RC2: OFF  -1
°  /OFF -2°
    
INPUT VOLTAGE: 24.5 V
PORT1/PORT2/CAN: - -/- -/OK
CAN ID: 39713   CPU/PWR: */* 
PROCESSOR UNIT  ID: 39768
*: Version no.
**.**: Program version no.
Not shown with Fantum Feedback
TM
.
For Fantum Feedback
TM
, “FANTUM 
FEEDBACK” is displayed.
ROM: OK  6454011-**.**
 6454010-**.**
RAM: OK  BACKUP: OK
COMMUNICATION: OK
CONTROLLER ID: 2
CAN ID: 0  CPU:* 
         CONTROL UNIT
*: Version no.
**.**: Program version no.