Furuno 711c Manual De Usuario

7.  INITIAL SETTINGS

The [Dockside Setup] menu for the rudder reference unit (RRU) and Fantum Feed-
back

TM 

is different. To open the [Dockside Setup] menu, select [Dockside Setup] from 

the [Installation Menu] window.

Note: The [Dockside Setup] menu is not shown when [Boat Type] is set to [EVCS 
Boat].

1. Select the current setting for [Select RRU Type] from the 

[Dockside Setup] menu then push the Course control 
knob.

2. Rotate the Course control knob to select a correct option then push the knob.

[Rotary(Inboard)]: For FURUNO rudder reference unit FAP-6112.
[Linear(Outboard)]: For Teleflex linear sensor AR4502.

1. Select [RRU Sensor Alignment] from the [Dockside Setup] menu then push the 

Course control knob.
The message shown below appears.

Select RRU Type: 

 Rotary (Inboard)

RRU Sensor Alignment

Air Bleeding:  No

Rudder Limit Setup

Auto Rudder Limit:

Manual Rudder Limit:

Rudder Test:  No

Dockside Setup

Rotary (Inboard)

Linear (Outboard)

Measure rudder center 
position and confirm
displayed value is < 5

°

if not, adjust RRU arm or 
magnet. NAVPILOT will
correct reversed RORT
& STBD indication later.
Push any key to continue