Furuno 711c Manual De Usuario

7.  INITIAL SETTINGS

6. Rotate the Course control knob to select [Safe Helm Response] then push the 

knob.

7. The cursor is selecting the current setting value for [Response]; push the Course 

control knob.

8. Rotate the Course control knob to select a value then push the knob (setting 

range: 1-10).
The higher the value the faster the response.

9. Press the 

 key to close the [Safe Helm Response] window.

10. Rotate the Course control knob to select the current setting for [Safe Helm Beep] 

then push the knob.

11. Rotate the Course control knob to select [ON] or [OFF] then push the knob. 

[Safe Helm Beep] turns the beep on or off when the safe helm mode is activated.

12. Press the 

 key to close the [Safe Helm/P.Assist] menu.

Perform the helm sensor test before doing the power assist setup. For details of the 
helm sensor test, see "Helm sensor test (for Accu-Steer FPS 12V (or 24V) 
drive)" on page 7-15.

1. Select [Safe Helm/P.Assist Setup] from the [Dockside Setup] menu then push the 

Course control knob.
[Safe Helm/P.Assist Setup] appears on the [Dockside Setup] menu after the helm 
sensor test is successfully completed.

2. Rotate the Course control knob to select the current setting for [Power Assist] 

then push the knob.

Safe Helm Response

Response: 

6     

          PORT STBD

Turn helm to PORT/STBD to set
Safe Helm response time.
Higher value = Faster
response.

Push MENU key to return

Not shown with Fantum Feedback

TM

.

When you turn the helm, 
PORT or STBD is highlighted 
according to the rudder 
direction.