Furuno 711c Manual De Usuario

5.  MAINTENANCE, TROUBLESHOOTING

This test checks the processor unit for correct operation. Open the diagnostic test op-
tions window, select [Processor Unit] then push the Course control knob. 

To close the test result, press the 

 key.

•  [Processor Unit ID]: ID of the processor unit
•  [ROM]: ROM test result ("OK" or “NG”), program number
•  [RAM]: RAM test result ("OK" or “NG”)
•  [Backup]: Backup data test result ("OK" or “NG”)
•  [Rudder Angle]: The test result of rudder reference unit ("OK" or “NG”). For Fantum 

Feedback

TM

, "Fantum Feedback" is displayed. Not shown when [Boat Type] is set 

to [EVCS Boat].

•  [Bypass/Clutch]: Presence or absence of bypass/clutch and bypass/clutch amper-

age. "Not Present" shown in case of no connection. Not shown when [Boat Type] is 
set to [EVCS Boat].

•  [RC1/RC2]: Remote controller state (ON or OFF) and rudder signal input value. Not 

shown with Fantum Feedback

TM

.

•  [INPUT VOLTAGE]: Source voltage
•  [Port1/Port2/CAN]: I/O test for NMEA0183 and CAN bus ("OK" or “NG”). 
•  [CAN ID]: ID of CAN bus equipment
•  [CPU/PWR]: CPU and PWR board version number

ROM: OK 

6454007-**.**

 6454009-**.**
RAM: OK    Backup: OK
Rudder Angle: OK    0

°

Bypass/Clutch: 0.7A
RC1/RC2: OFF  -1

°  /OFF -2°

    

Input Voltage: 24.5 V
Port1/Port2/CAN: - -/- -/OK
CAN ID: 39713     CPU/PWR: */* 

Processor Unit                     ID: 39768

*: Version no.
**.**: Program version no.