Schneider Electric HRB1684301-01 Manual De Usuario

54

HRB1684301-01

Chapter 5—Meter webpages

PowerLogic™ PM5500 series user manual

Before connecting the meter to your LAN, you must first configure the Ethernet settings.

1. Disconnect your computer from the network. If your computer has wireless 

communications, make sure you disable the wireless network connection as well.

2. Use an Ethernet cable to connect the computer to one of the meter’s Ethernet ports.

3. Open a web browser and enter 169.254.0.10 in the address box.

4. Log in to the meter webpages. The default login is:

— Username = user1
— Password = pass1

5. Click Setup > Ethernet.

6. Modify the Ethernet setup parameters with the settings your system administrator 

assigned for the meter, then press Apply.

7. Press Apply to send and save the new settings to the meter.

8. Disconnect the meter from the computer.

1. Re-establish the the computer’s connection to your LAN (plug the computer’s 

Ethernet cable back to your LAN connection or re-enable wireless communications 
to the LAN).

2. Connect the meter’s Ethernet port to your LAN.

3. Open a web browser and enter the meter’s IP address in the address box.

4. Log in to the meter webpages.

See “Setting up Ethernet communications” on page 40 for details on using the front 
panel to configure the Ethernet port.

Ethernet

MAC Address

Displays the meter’s factory-programmed MAC address. 
This information is read-only and cannot be changed.

IP Parameters

IP Address Acquistion 
Mode

This controls the network protocol for your device (which the 
meter uses to obtain its IP address):
•

DHCP: Dynamic Host Configuration Protocol

1

•

BOOTp: Bootstrap Protocol

•

Static: Use the static value programmed in the IP 
Address setup register

•

Default: Use 85.16 as the first two values of the IP 
address, then convert the last two hexadecimal values of 
the MAC address to decimal and use this as the last two 
values of the IP address.
Example: MAC address = 00:80:67:82:B8:C8
Default IP = 85.16.184.200

1

FQDN (fully qualified device name) is not supported. The device name is not automatically sent to a DNS 
server when a DHCP request is sent. In order to use device name instead of IP address, your IT 
administrator must manually add the device name to the DNS.

IP Address

The internet protocol address of your device.

Subnet Mask

The Ethernet IP subnetwork address of your network 
(subnet mask).

Default Gateway

The Ethernet IP gatway address of your network.