Schneider Electric HRB1684301-01 Manual De Usuario

HRB1684301-01

69

This section describes the meter’s I/O (input/output) features. 

The meter is equipped with:

•

four (4) digital input ports (S1 to S4), and

•

two (2) Form A digital output ports (D1 and D2).

After you wire the meter’s digital I/O ports, you can configure these ports so you can 
use the meter to perform I/O functions.

Digital inputs are typically used for monitoring the status of external contacts or circuit 
breakers. They can also be used for pulse counting or input metering applications, such 
as WAGES (water, air, gas, electricity, steam) monitoring.

The meter’s digital inputs require an external voltage source to detect the digital input’s 
on/off state. The meter detects an on state if the external voltage appearing at the 
digital input is within its operating range.

•

See “Specifications” on page 27 for electrical characteristics and limits for the digital 
inputs.

• Apply appropriate personal protective equipment (PPE) and follow safe electrical 

work practices. See NFPA 70E in the USA or applicable local standards.

• Turn off all power supplying this device before working on it.
• Always use a properly rated voltage sensing device to confirm that all power is off.
• Do not exceed the device’s ratings for maximum limits.
• Do not use this device for critical control or protection applications where human or 

equipment safety relies on the operation of the control circuit.

S1

S2

S3

S4

+

+

+

+

-

-

-

-

+

-

18 - 30 V AC
12 - 60 V DC

+

-

18 - 30 V AC
12 - 60 V DC

+

-

+

-

18 - 30 V AC
12 - 60 V DC

18 - 30 V AC
12 - 60 V DC