Graco 249884 Series B Manual De Usuario

During system installation, double-faced tape can be 
used to allow relocation of the Transceivers to optimize 
RF communication.

Once RF communications are confirmed, the Trans-
ceiver can be permanently mounted on a desk top, wall, 
or ceiling. If the component will be placed on a desktop 
or horizontal flat surface, use the rubber feet that are 
supplied. The feet are adhered to round indents on the 
back side of the unit. If the component will be placed on 
the wall or ceiling, use the Matrix mounting bracket (3) 
and screws (4) to fasten the box to the mounting loca-
tion. See F

IG

. 12.

1.

Using the bracket as a template, mark the location 
of the bracket holes on the mounting surface. Or see 
Mounting Bracket Hole Dimensions, page 17.

2.

Drill two holes.

3.

Attach the bracket (3) to the wall or ceiling using two 
1 in. sheet rock screws (4). Slide the transceiver 
onto the bracket.

•

If the Transceiver is mounted outdoors, it must 
be placed into a protective water proof, 
non-metallic outside housing meeting IP65 
Standards for outdoor use.

•

Be sure to comply with all applicable local, 
state, and national fire, electrical, and safety 
regulations.

3

4