Amana Bottom Mount Refrigerator Manual De Usuario

RS1200001

44

November 1996

Water valve

energized

7.5 seconds

140 cc fill 

11:00 position

Ejector blade 

stop position
1:30 position

Start position: 

thermostat closes, 

motor on, 
heater on

Ejector stall on ice,

motor on 

(30 seconds to 5 minutes) 

4:00 position

6:00 position

Thermostat

opens in this

range and 

heater is off

Turning water level adjustment screw will move
contact in relationship with contact ring segment. This
causes contact to vary time water valve is energized.
Contact ring is tapered at end of fill time.

• Turning screw clockwise decreases fill time.
• Turning screw counterclockwise increases fill time.
• 1/2 turn equals 20 cc or 1.2 seconds.
• Full turn equals 40 cc or 2.4 seconds.

Ejector Blades or Stripper
1. Remove module and support assembly.
2. Install ejector blades, realigning "D" coupling with

module cam.

Accessing Control Box
1. Remove motor and contact assembly from control

box by removing 3 screws.

2. Remove shut-off arm.
3. Pull free.

Mold and heater screw access ports

Switches will jam if turned counterclockwise and
gears will be destroyed if turned clockwise. Advance
ice maker into cycle by using a jumper to bridge H to
R. Ice maker will not run if motor is defective. Shut-off
arm must be in on position.

There are several slotted shafts on motor assembly
board. Do not insert screwdriver and attempt to turn
shafts. Slots permit assembly only.

There are nonrepairable and nonreplaceable
components in module. When diagnosing or repairing
ice maker, do not remove module unless replacing
module.

To avoid main assembly damage do not
rotate blades or drive gear.